AK4180VT AKM [Asahi Kasei Microsystems], AK4180VT Datasheet - Page 7

• Manufacturer Part Number: AK4180VT
• Description: Touch Screen Controller
• Manufacturer: AKM [Asahi Kasei Microsystems]

[ASAHI KASEI]
The AK4180 incorporates a12-bit successive approximation resistor A/D converter for position measurement, temperature, and
battery voltage. The architecture is based on capacitive redistribution algorithm, and an internal capacitor array functions as the
sample/hold circuit.
The A/D converter output is a straight binary format as shown below:
The A/D converter’s full scale measurements depend on the input mode.
Analog input is selected via the A2, A1, A0 and SER/ DFR bits in the control register. If the analog inputs are the X or Y-axis,
use SER/ DFR = “0”, which means differential mode, the full scale ( VREF) is the differential voltage between the non-inverting
terminal and the inverting terminal of the measured axis (e.g. (XP) – (XN)). Analog non-inverting input to A/D converter is the
non-inverting terminal of the non-measured axis while the inverting input is the inverting terminal of the measured axis. If the
SER/ DFR bit is set to “1”, which means single-ended mode, the full scale of A/D converter ( VREF) is the internal reference
voltage, or external reference voltage. Note that SER/ DFR bit should be set to ”0” if IN2 is selected as analog input;
nevertheless, IN2 is actually measured by single-ended mode.
Tracking time is the period from the falling edge of 5
the required settling time to charge the internal capacitors depends on the source impedance. If the source impedance, Rin, is 600
ohm, the settling time needs at least 1.5 s (3 tDCLK@2MHz). The maximum throughput of A/D converter is 125kHz.
If the source impedance of analog input is larger than 600 ohm, longer tracking time is required.
The selected touch screen position is detected by the voltage measurement of one axis when the voltage is supplied between the
two terminals of the other axis. At least two A/D conversions are needed to get the two-dimensional (X/Y axis) position.
<MS0195-E-01>
A/D Converter for Touch Screen
Analog Inputs
The Position Detection of Touch Screen
( VREF-2.5LSB) ~ ( VREF-1.5LSB)
( VREF-1.5LSB)~ VREF
0.5LSB ~ 1.5LSB
Input Voltage
0 ~ 0.5LSB
---------
VREF: (VREF+) – (VREF-)
th
Table 1 Output Code
DCLK to the falling edge of 8
7
Output Code
---------
th
FFF
FFE
001
000
DCLK after the detection of START bit.
2003/02
[AK4180]