92HD66C IDT [Integrated Device Technology], 92HD66C Datasheet - Page 32

no-image

92HD66C

Manufacturer Part Number
92HD66C
Description
SIX CHANNEL HD AUDIO CODECS
Manufacturer
IDT [Integrated Device Technology]
Datasheet
92HD66C
SIX CHANNEL HD AUDIO CODECS WITH DUAL CAPLESS HEADPHONE AMPLIFIERS
IDT CONFIDENTIAL
©2011 INTEGRATED DEVICE TECHNOLOGY, INC.
2.22. Headphone Drivers
2.23. GPIO
GPIO
#
0
1
2
3
4
2.23.1. GPIO Pin mapping and shared functions
2.23.2. Digital Microphone/GPIO Selection
package
48 pin
46
48
44
2
4
PC-Beep may be attenuated and distorted when the CODEC is in D3 depending on the load imped-
ance seen by the output amplifier since all ports are in a low power state while in D3. Load imped-
ances of 10K or larger can support full scale outputs but lower impedance loads will distort unless
the output amplitude is reduced. Digital PC_Beep requires a clock to operate and the CODEC will
prevent the system from stopping the bus clock while in D3 by setting the Clock_Stop_OK bit to 0 to
indicate that the part requires a clock.
The codec implements headphone capable outputs on some ports. The Microsoft Windows Logo
Program allows up to the equivalent of 100ohms in series. However, an output level of +3dBV at the
pin is required to support 300mV at the jack with a 32ohm load and 1V with a 320 ohm load. Micro-
soft allows device and system manufactures to limit output voltages to address EU safety require-
ments. (WLP 3.09 - please refer to the latest Windows Logo Program requirements from Microsoft.)
The 92HD90 codec does not implement power limiting. Power limiting may be implemented through
the use of an external series resistance.
Although 3 Headphone amplifiers are present, only two may be used simultaneously. Headphone
performance will degrade if more than one port is driving a 32 ohm load.
2 functions are available on the DMIC_CLK/GPIO1 and the DMIC_0/GPIO2 pins. To determine
which function is enabled, the order of precedence is followed:
1. If GPIOs are not enabled through the AFG, then at reset, the pins are pulled low by an internal
2. If the GPIO 1 is enabled, the 2 DMIC pins become mute (unless programmed for GPIO or SPDIF
3. If GPIO2 is enabled through the AFG, pin 4 (3 on 40-pin package) becomes a GPIO and is
4. If the port is enabled as an input, the digital microphone will be used.
5. If the port is not enabled as an input or if the pin is configured as a GPIO, the digital microphone
package
40 pin
pull-down resistor.
use) and pin2 becomes GPIO with an internal pull-down.
pulled low by an internal pull-down resistor.
path will be mute.
38
40
2
3
Supply
DVDD
DVDD
DVDD
DVDD
DVDD
SPDIF
In
SPDIF
YES
YES
Out
32
EAPD
GPI/O VrefOut DMIC
YES
YES
YES
YES
YES
CLK
IN
IN
IN
Pull
Up
Down
Pull
50K
50K
50K
50K
50K
V 1.0 2/12
92HD66C

Related parts for 92HD66C