LC151X01 PHILIPS [NXP Semiconductors], LC151X01 Datasheet - Page 26

• Manufacturer Part Number: LC151X01
• Description: 15.1 Title XGA TFT LCD
• Manufacturer: PHILIPS [NXP Semiconductors]

9. PRECAUTIONS
9-1. MOUNTING PRECAUTIONS
9-2. OPERATING PRECAUTIONS
(1) You must mount a module using holes arranged in four corners or four sides.
(2) You should consider the mounting structure so that uneven force (ex. Twisted stress) is not applied to the
(3) Please attach the surface transparent protective plate to the surface in order to protect the polarizer.
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not desirable because the former
(6) Do not touch, push or rub the exposed polarizers with glass, tweezers or anything harder than HB
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft materials like
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer causes
(9) Do not open the case because inside circuits do not have sufficient strength.
(1) The spike noise causes the mis-operation of circuits. It should be lower than following voltage :
(2) Response time depends on the temperature.(In lower temperature, it becomes longer.)
(3) Brightness depends on the temperature. (In lower temperature, it becomes lower.)
(4) Be careful for condensation at sudden temperature change. Condensation makes damage to polarizer or
(5) When fixed patterns are displayed for a long time, remnant image is likely to occur.
(6) Module has high frequency circuits. Sufficient suppression to the electromagnetic interference shall be
Please pay attention to the followings when you use this TFT LCD module.
Ver. 0.2
Transparent protective plate should have sufficient strength in order to the resist external force.
pencil lead. And please do not rub with dust clothes with chemical treatment.
to the polarizer.)
And in lower temperature, response time(required time that brightness is stable after turned on) becomes
force is not transmitted directly to the module.
by electro-chemical reaction.
chamois soaks with petroleum benzene. Normal-hexane is recommended for cleaning the adhesives
used to attach front / rear polarizers. Do not use acetone, toluene and alcohol because they cause
chemical damage to the polarizer.
deformations and color fading.
V= 200mV(Over and under shoot voltage)
longer.
electrical contacted parts. And after fading condensation, smear or spot will occur.
done by system manufacturers. Grounding and shielding methods may be important to minimized the
interference.
generates corrosive gas of attacking the polarizer at high temperature and the latter causes circuit break
module. And the case on which a module is mounted should have sufficient strength so that external
Do not touch the surface of polarizer for bare hand or greasy cloth.(Some cosmetics are detrimental
Product Specification
Mar.06. 2002
Liquid Crystal Display
LC151X01
26 / 27