24VL014H/MS Microchip Technology, 24VL014H/MS Datasheet

IC EEPROM 1KBIT 400KHZ 8MSOP

24VL014H/MS

Manufacturer Part Number
24VL014H/MS
Description
IC EEPROM 1KBIT 400KHZ 8MSOP
Manufacturer
Microchip Technology
Datasheet

Specifications of 24VL014H/MS

Memory Size
1K (128 x 8)
Package / Case
8-MSOP, Micro8™, 8-uMAX, 8-uSOP,
Format - Memory
EEPROMs - Serial
Memory Type
EEPROM
Speed
100kHz, 400kHz
Interface
I²C, 2-Wire Serial
Voltage - Supply
1.5 V ~ 3.6 V
Operating Temperature
-20°C ~ 85°C
Organization
128 K x 8
Interface Type
I2C
Maximum Clock Frequency
0.4 MHz
Access Time
900 ns
Supply Voltage (max)
3.6 V
Supply Voltage (min)
1.5 V
Maximum Operating Current
3 mA
Maximum Operating Temperature
+ 85 C
Mounting Style
SMD/SMT
Minimum Operating Temperature
- 20 C
Operating Supply Voltage
1.8 V , 2.5 V , 3.3 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Device Selection Table
Features:
• Single-Supply with Operation Down to 1.5V
• Low-Power CMOS Technology:
• 2-Wire Serial Interface Bus, I
• Schmitt Trigger Inputs for Noise Suppression
• Output Slope Control to Eliminate Ground Bounce
• 100 kHz and 400 kHz Compatibility
• Page Write Buffer for up to 16 Bytes
• Self-Timed Write Cycle (including Auto-Erase)
• Hardware Write Protection for Half Array
• Cascadable up to Eight Devices
• More than 1 Million Erase/Write Cycles
• ESD Protection > 4,000V
• Data Retention > 200 Years
• Factory Programming (QTP) Available
• 8-pin PDIP, SOIC, TSSOP, TDFN and MSOP
• Temperature Range:
• Pb-Free and RoHS Compliant
© 2008 Microchip Technology Inc.
- 400 μA active current, maximum
- 1 μA standby current, maximum
(40h-7Fh)
Packages
Part Number
Note 1: 100 kHz for V
- -20°C to +85°C
1K I
24VL014H
2
C
Serial EEPROM with Half-Array Write-Protect
V
1.5 to 3.6V
CC
Range
CC
< 1.8V
2
C™ Compatible
Max Clock
400 kHz
(1)
Description:
The Microchip Technology Inc. 24VL014H is a 1 Kbit
Serial Electrically Erasable PROM with operation
down to 1.5V. The device is organized as a single block
of 128 x 8-bit memory with a 2-wire serial interface.
Low-current design permits operation with maximum
standby and active currents of only 1 μA and 400 μA,
respectively. The device has a page write capability for
up to 16 bytes of data. Functional address lines allow
the connection of up to eight 24VL014H devices on the
same bus for up to 8 Kbits of contiguous EEPROM
memory. The device is available in the standard 8-pin
PDIP, 8-pin SOIC (150 mil), TSSOP, 2x3 TDFN and
MSOP packages.
Block Diagram
Package Types
V
SDA SCL
A0 A1 A2
A0
A1
A2
Control
SS
Logic
V
V
I/O
CC
SS
1
2
3
4
PDIP, MSOP
Memory
Control
Logic
WP
V
A0
A2
A1
SS
24VL014H
8
7
6
5
1
2
3
4
V
WP
SCL
SDA
TDFN
CC
XDEC
V
A0
A1
A2
SS
8
7
6
5
V
WP
SCL
SDA
CC
SOIC, TSSOP
1
2
3
4
HV Generator
Write-Protect
EEPROM
Sense Amp.
R/W Control
DS22116A-page 1
Circuitry
YDEC
Array
8
7
6
5
V
WP
SCL
SDA
CC

Related parts for 24VL014H/MS

24VL014H/MS Summary of contents

Page 1

... Pb-Free and RoHS Compliant © 2008 Microchip Technology Inc. Description: Max Clock The Microchip Technology Inc. 24VL014H Kbit Serial Electrically Erasable PROM with operation (1) 400 kHz down to 1.5V. The device is organized as a single block of 128 x 8-bit memory with a 2-wire serial interface. ...

Page 2

... V — V (Note) CC — 0. μA — ± μA — ±1 V OUT — 25° MHz A μA — 400 V CC — μA — +1.0V CC Conditions = 3.6V (Note) = 3.6V, SCL = 400 kHz = 3.6V = 3.6V, SCL = SDA = A0, A1 © 2008 Microchip Technology Inc. ...

Page 3

... This eliminates the need for This parameter is not tested but ensured by characterization. For endurance estimates in a specific application, please consult the Total Endurance™ Model which can be obtained from Microchip’s web site at www.microchip.com. © 2008 Microchip Technology Inc. Electrical Characteristics +1.5V to 3.6V T ...

Page 4

... FIGURE 1-1: BUS TIMING DATA 5 SCL 7 3 SDA SDA Out WP DS22116A-page (protected) 11 (unprotected © 2008 Microchip Technology Inc. ...

Page 5

... A2 are hard-wired to logic ‘0’ or logic ‘1’. For applications in which these pins are controlled by a microcontroller or other programmable device, the chip address pins must be driven to logic ‘0’ or logic ‘1’ before normal device operation can proceed. © 2008 Microchip Technology Inc. 8-pin 8-pin 8-pin TSSOP ...

Page 6

... Serial Clock (SCL), controls the bus access and generates the Start and Stop conditions, while the 24VL014H works as slave. Both master and slave can operate as transmitter or receiver, but the master device determines which mode is activated. DS22116A-page 6 © 2008 Microchip Technology Inc. ...

Page 7

... Transmitter must release the SDA line at this point allowing the Receiver to pull the SDA line low to acknowledge the previous eight bits of data. © 2008 Microchip Technology Inc. The data on the line must be changed during the low period of the clock signal. There is one bit of data per clock pulse ...

Page 8

... In this case, software can use A0 of the control byte as address bit A7 address bit A8, and A2 as address bit A9 not possible to sequentially read across device boundaries. © 2008 Microchip Technology Inc. A0 R/W ACK ...

Page 9

... Byte T SDA Line S Bus Activity © 2008 Microchip Technology Inc. The higher order three bits of the word address remain constant. If the master should transmit more than 16 bytes prior to generating the Stop condition, the address counter will roll over and the previously received data will be overwritten ...

Page 10

... Read or Write command. See Figure 7-1 for a flow diagram of this operation. DS22116A-page 10 FIGURE 7-1: ACKNOWLEDGE POLLING FLOW Send Write Command Send Stop Condition to Initiate Write Cycle Send Start Send Control Byte with R Did Device No Acknowledge (ACK = 0)? Yes Next Operation © 2008 Microchip Technology Inc. ...

Page 11

... Bus Activity Master SDA Line Bus Activity © 2008 Microchip Technology Inc. Once the word address is sent, the master generates a Start condition following the acknowledge. This terminates the write operation, but not before the internal Address Pointer is set. The master then issues the control byte again but with the R/W bit set to a ‘ ...

Page 12

... FIGURE 8-2: RANDOM READ S T Bus Activity Control A Master Byte SDA Line Bus Activity FIGURE 8-3: SEQUENTIAL READ Bus Activity Control Master Byte SDA Line Bus Activity DS22116A-page Word Control A Address (n) Byte Data (n) Data ( Data ( Data ( Data ( © 2008 Microchip Technology Inc. ...

Page 13

... PDIP (300 mil) XXXXXXXX T/XXXNNN YYWW 8-Lead SOIC (3.90 mm) XXXXXXXT XXXXYYWW NNN 8-Lead TSSOP XXXX TYWW NNN 8-Lead MSOP XXXXXT YWWNNN 8-Lead 2x3 TDFN XXX YWW NN © 2008 Microchip Technology Inc. 24VL014H Example: 24VL014H 112F 0821 Example: 24VL14H 0821 12F Example: V14H 821 ...

Page 14

... Note: Please visit www.microchip.com/Pbfree for the latest information on Pb-free conversion. *Standard OTP marking consists of Microchip part number, year code, week code, and traceability code. DS22116A-page 14 © 2008 Microchip Technology Inc. ...

Page 15

... Microchip Technology Inc. 24VL014H DS22116A-page 15 ...

Page 16

... DS22116A-page 16 α φ β © 2008 Microchip Technology Inc. ...

Page 17

... Microchip Technology Inc. 24VL014H DS22116A-page 17 ...

Page 18

... DS22116A-page 18 φ I © 2008 Microchip Technology Inc. ...

Page 19

... Microchip Technology Inc. 24VL014H I φ DS22116A-page 19 ...

Page 20

... DS22116A-page 20 © 2008 Microchip Technology Inc. ...

Page 21

... Microchip Technology Inc. 24VL014H DS22116A-page 21 ...

Page 22

... REVISION HISTORY Revision A (11/2008) Original release. DS22116A-page 22 © 2008 Microchip Technology Inc. ...

Page 23

... To register, access the Microchip web site at www.microchip.com, click on Customer Change Notification and follow the registration instructions. © 2008 Microchip Technology Inc. CUSTOMER SUPPORT Users of Microchip products can receive assistance through several channels: • Distributor or Representative • ...

Page 24

... What deletions from the document could be made without affecting the overall usefulness there any incorrect or misleading information (what and where)? 7. How would you improve this document? DS22116A-page 24 Total Pages Sent ________ FAX: (______) _________ - _________ N Literature Number: DS22116A © 2008 Microchip Technology Inc. ...

Page 25

... TSSOP, (4.4 mm Body), 8-lead MS = MSOP, (Plastic Micro Small Outline), 8-lead (1) MNY = TDFN, (2x3x0.75 mm Body), 8-lead Note 1: “Y” indicates a Nickel Palladium Gold (NiPdAu) finish. © 2008 Microchip Technology Inc. 24VL014H . Examples: a) 24VL014H/P: 1.5V, PDIP Package. b) 24VL014H/SN: 1.5V, SOIC Package. c) 24VL014HT/ST: 1.5V, TSSOP Package, ...

Page 26

... NOTES: DS22116A-page 26 © 2008 Microchip Technology Inc. ...

Page 27

... PowerMate, PowerTool, REAL ICE, rfLAB, Select Mode, Total Endurance, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies. ...

Page 28

... Fax: 886-3-572-6459 Taiwan - Kaohsiung Tel: 886-7-536-4818 Fax: 886-7-536-4803 Taiwan - Taipei Tel: 886-2-2500-6610 Fax: 886-2-2508-0102 Thailand - Bangkok Tel: 66-2-694-1351 Fax: 66-2-694-1350 © 2008 Microchip Technology Inc. EUROPE Austria - Wels Tel: 43-7242-2244-39 Fax: 43-7242-2244-393 Denmark - Copenhagen Tel: 45-4450-2828 Fax: 45-4485-2829 France - Paris Tel: 33-1-69-53-63-20 ...

Related keywords