M93C56-WMN6TP STMicroelectronics, M93C56-WMN6TP Datasheet - Page 9

• Manufacturer Part Number: M93C56-WMN6TP
• Description: IC EEPROM 2KBIT 2MHZ 8SOIC
• Manufacturer: STMicroelectronics

Specifications of M93C56-WMN6TP

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 2K (256 x 8 or 128 x 16)
• Speed: 2MHz
• Interface: Microwire, 3-Wire Serial
• Voltage - Supply: 2.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8658-2; M93C56-WMN6TP

M93C86, M93C76, M93C66, M93C56, M93C46
2
Connecting to the serial bus
Figure 3
Only one device is selected at a time, so only one device drives the Serial Data output (Q)
line at a time, the other devices are high impedance.
The pull-down resistor R (represented in
bus master leaves the S line in the high impedance state.
In applications where the bus master may be in a state where all inputs/outputs are high
impedance at the same time (for example, if the bus master is reset during the transmission
of an instruction), the clock line (C) must be connected to an external pull-down resistor so
that, if all inputs/outputs become high impedance, the C line is pulled low (while the S line is
pulled low): this ensures that C does not become high at the same time as S goes low, and
so, that the t
Figure 3.
CS3 CS2 CS1
Bus master
shows an example of three memory devices connected to an MCU, on a serial bus.
SLCH
Bus master and memory devices on the serial bus
SDO
SCK
SDI
requirement is met. The typical value of R is 100 k .
R
R
C Q D
S
memory device
Doc ID 4997 Rev 11
M93xxx
ORG
V
CC
Figure
V
R
SS
3) ensures that no device is selected if the
C Q D
memory device
S
M93xxx
ORG
V
CC
Connecting to the serial bus
V
R
SS
C Q D
memory device
S
M93xxx
V
CC
ORG
AI14377b
V
SS
V
V
CC
SS
9/36