DS2502S+ Maxim Integrated Products, DS2502S+ Datasheet - Page 22

• Manufacturer Part Number: DS2502S+
• Description: IC OTP 1KBIT 8SOIC
• Manufacturer: Maxim Integrated Products

Specifications of DS2502S+

• Format - Memory: EPROMs
• Memory Type: OTP EPROM
• Memory Size: 1K (1K x 1)
• Interface: 1-Wire Serial
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Organization: 1 K x 1
• Supply Voltage (max): 6 V
• Supply Voltage (min): 2.8 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Speed: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

NOTES:
1. All voltages are referenced to ground.
2. V
3. Input load is to ground.
4. An additional reset or communication sequence cannot begin until the reset high time has expired.
5. Read data setup time refers to the time the host must pull the 1-Wire bus low to read a bit. Data is
6. V
7. 30 nanocoulombs per 72 time slots @ 5.0V.
8. At V
9. Capacitance on the data pin could be 800 pF when power is first applied. If a 5 k resistor is used to
10. Maximum 1-Wire voltage for programming parameters is 11.5V to 12.0V; temperature range is -40°C
11. Under certain low-voltage conditions V
12. The accumulative duration of the programming pulses for each address must not exceed 5 ms.
13. IC operation and 1-wire communication is valid at V
14. Reset low pulse on DQ must be preceded by a valid t
guaranteed to be valid within 1 s of this falling edge and will remain valid for 14 µs minimum. (15
µs total from falling edge on 1-Wire bus.)
pullup the data line to V
normal communications.
to +50°C.
guarantee a presence pulse.
only valid when V
voltage of 2.5V.
PUP
IH
is a function of the external pullup resistor and the pull-up voltage.
CC
= external pullup voltage.
=5.0V with a 5 k pullup to V
PUP
=2.8V or higher.
CC
, 5 µs after power has been applied the parasite capacitance will not affect
CC
ILMAX
and a maximum time slot of 120 µs.
22 of 23
may have to be reduced to as much as 0.5V to always
PUP
REC
=2.5V or higher, but EPROM data read is
recovery time above the minimum V
PUP