DM330023-2 Microchip Technology, DM330023-2 Datasheet - Page 66

• Manufacturer Part Number: DM330023-2
• Description: Power Management IC Development Tools dsPICDE MCHV-2
• Manufacturer: Microchip Technology
• Type: Motor / Motion Controllers & Driversr

Specifications of DM330023-2

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: PIC24F, PIC24E, dsPIC33F, dsPIC33E
• Input Voltage: 90 V to 265 V
• Output Voltage: 15 V
• Interface Type: UART
• Output Current: 0.75 A
• For Use With: PIC24F, PIC24E, dsPIC33F, dsPIC33E

B.2
DS52074A-page 66
RUNNING THE APPLICATION
4. Select Debugger>Program to program the application code into the target PIC24
The Starter Kit on Board executes in either real-time (Run) or steps (Step Into, Step
Over, and Animate) real-time execution occurs when you select Run in MPLAB IDE.
Once the target device code is halted, either by Halt or a breakpoint, you can step.
Toolbar buttons can be used for quick access to commonly used debug operations.
Refer to Section 3.3 “Running the Example Application” in the “MPLAB Starter Kit for
dsPIC
To see how these options function, do the following:
1. Select Debugger>Reset>Processor Reset or click the Reset button to reset the
2. Select Debugger>Run or click the Run button. Observe how the application operates.
3. Select Debugger>Halt or click the Halt button to stop the program execution. A
4. Select Debugger>Step Into or click the Step Into button to step the program exe-
5. Select Debugger>Reset>Processor Reset or click the Reset button to reset the
Note:
Note:
MCU or dsPIC DSC device on the dsPICDEM MCHV-2 Development board. The
debug programming progress will be visible in the Starter Kit on Board tab of the
Output window.
program.
green solid arrow will mark the line of code in the File window where the program
halted.
cution once. The green solid arrow will move down one line of code in the File
window. Repeatedly click the button to step through the code.
program again. The arrow will disappear, meaning the device is reset.
®
Digital Signal Controllers User’s Guide” (DS51700).
Debug executive code is automatically programmed in the upper program
memory of the Starter Kit on Board device when the Starter Kit on Board is
selected as a debugger. Debug code must be programmed into the target
device to use the in-circuit debugging capabilities of the Starter Kit on
Board.
All the peripherals are frozen when the “Halt” button is pressed to stop the
program execution.
 2012 Microchip Technology Inc.