LM3410XMF/NOPB National Semiconductor, LM3410XMF/NOPB Datasheet - Page 17

• Manufacturer Part Number: LM3410XMF/NOPB
• Description: IC DRVR WT/OLED BCKLT SOT23-5
• Manufacturer: National Semiconductor
• Series: PowerWise®r
• Type: Backlight, OLED, White LEDr

Specifications of LM3410XMF/NOPB

• Constant Current: Yes
• Topology: PWM, SEPIC, Step-Up (Boost)
• Number Of Outputs: 1
• Internal Driver: Yes
• Type - Primary: Automotive, Backlight, Flash/Torch
• Type - Secondary: High Brightness LED (HBLED), OLED, White LED
• Frequency: 1.2MHz ~ 2MHz
• Voltage - Supply: 2.7 V ~ 5.5 V
• Voltage - Output: 3 V ~ 24 V
• Mounting Type: Surface Mount
• Package / Case: SOT-23-5, SC-74A, SOT-25
• Operating Temperature: -40°C ~ 125°C
• Current - Output / Channel: 2.8A
• Internal Switch(s): Yes
• Efficiency: 88%
• Operating Supply Voltage (typ): 3.3/5V
• Number Of Segments: 5
• Operating Temperature (min): -40C
• Operating Temperature (max): 125C
• Operating Temperature Classification: Automotive
• Package Type: SOT-23
• Pin Count: 5
• Mounting: Surface Mount
• Power Dissipation: 400mW
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 5.5V
• For Use With: LM3410XMFLEDEV - BOARD EVAL LM3410 BOOST SOT23
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: LM3410XMFTR

analysis of the LM3410 Boost Converter is applicable to the
LM3410 SEPIC Converter.
SEPIC Design Guide:
SEPIC Conversion ratio without loss elements:
Therefore:
Small ripple approximation:
In a well-designed SEPIC converter, the output voltage, and
input voltage ripple, the inductor ripple I
comparison to the DC magnitude. Therefore it is a safe ap-
proximation to assume a DC value for these components. The
main objective of the Steady State Analysis is to determine
the steady state duty-cycle, voltage and current stresses on
all components, and proper values for all components.
In a steady-state converter, the net volt-seconds across an
inductor after one cycle will equal zero. Also, the charge into
a capacitor will equal the charge out of a capacitor in one cy-
cle.
Therefore:
Substituting I
L1
into I
L2
I
L2
= I
LED
FIGURE 14. HB/OLED SEPIC CONVERTER Schematic
L1
and I
L2
is small in
17
The average inductor current of L2 is the average output load.
Applying Charge balance on C1:
Since there are no DC voltages across either inductor, and
capacitor C3 is connected to Vin through L1 at one end, or to
ground through L2 on the other end, we can say that
Therefore:
This verifies the original conversion ratio equation.
It is important to remember that the internal switch current is
equal to I
so that the minimum guaranteed peak switch current limit
(2.1A) is not exceeded.
FIGURE 13. Inductor Volt-Sec Balance Waveform
L1
and I
L2
during the D interval. Design the converter
V
C3
= V
IN
30038552
www.national.com
30038556