STDS75M2E STMicroelectronics, STDS75M2E Datasheet - Page 13

• Manufacturer Part Number: STDS75M2E
• Description: IC TEMP SENSOR DIGITAL SO-8
• Manufacturer: STMicroelectronics

Specifications of STDS75M2E

• Function: Temp Sensor, Watchdog
• Topology: ADC (Sigma Delta), Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -55°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: No
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -55°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Full Temp Accuracy: +/- 3 C
• Digital Output - Bus Interface: Serial (2-Wire, I2C)
• Digital Output - Number Of Bits: 12 bit
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• Ic Output Type: Digital
• Sensing Accuracy Range: ± 0.5°C
• Temperature Sensing Range: -55°C To +125°C
• Supply Current: 125µA
• Supply Voltage Range: 2.7V To 5.5V
• Sensor Case Style: SOIC
• No. Of Pins: 8
• Rohs Compliant: Yes
• For Use With: 497-6238 - BOARD STLM75/STDS75/ST72F651
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STDS75
2.4
Note:
Interrupt mode
In Interrupt mode, the OS/INT output first becomes active when the measured temperature
exceeds the T
configuration register. Once activated, the OS/INT can only be cleared by either putting the
STDS75 into shutdown mode or by reading from any register (temperature, configuration,
T
reactivated when the measured temperature falls below the T
number of times equal to the FT value.
response for STDS75 configured to have a fault tolerance of 2. The interrupt/clear process
is cyclical between T
Figure 5.
1. This assumes that a READ has occurred.
The STDS75 is configured to have a fault tolerance of 2 in this example.
OS
, or T
OS Output - Comparator mode
OS Output - Interrupt mode
HYS
) on the device. Once the OS/INT has been deactivated, it will only be
OS output temperature response diagram
OS
value a consecutive number of times equal to the FT value in the
Temperature
OS
and T
Inactive
Inactive
Active
Active
T HYS
T OS
HYS
Doc ID 13297 Rev 8
.
Figure 5
(1)
illustrates typical OS output temperature
(1)
Conversions
HYS
(1)
value a consecutive
Operation
AI12224b
13/39