PS2561L1-1-A CEL, PS2561L1-1-A Datasheet - Page 15
![no-image](/images/manufacturer_photos/0/1/129/cel_sml.jpg)
PS2561L1-1-A
Manufacturer Part Number
PS2561L1-1-A
Description
PHOTOCOUPLER ICH TRANS 4DIP WIDE
Manufacturer
CEL
Series
NEPOCr
Datasheet
1.PS2561-1-A.pdf
(19 pages)
Specifications of PS2561L1-1-A
Number Of Channels
1
Input Type
DC
Voltage - Isolation
5000Vrms
Current Transfer Ratio (min)
80% @ 5mA
Current Transfer Ratio (max)
400% @ 5mA
Voltage - Output
80V
Current - Output / Channel
50mA
Current - Dc Forward (if)
80mA
Vce Saturation (max)
300mV
Output Type
Transistor
Mounting Type
Through Hole
Package / Case
4-DIP (0.400", 10.16mm)
Forward Current
10 mA
Maximum Input Diode Current
10 mA
Maximum Reverse Diode Voltage
5 V
Output Device
Phototransistor
Configuration
1 Channel
Maximum Collector Emitter Voltage
80 V
Maximum Collector Emitter Saturation Voltage
0.3 V
Isolation Voltage
5000 Vrms
Current Transfer Ratio
200 %
Maximum Forward Diode Voltage
1.4 V
Maximum Power Dissipation
150 mW
Maximum Operating Temperature
+ 100 C
Minimum Operating Temperature
- 55 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
(2) Wave soldering
(3) Soldering by soldering iron
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220 C
• Time to preheat temperature from 120 to 180 C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100 C.
260 C or below (molten solder temperature)
10 seconds or less
120 C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Data Sheet PN10234EJ04V0DS
350 C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
260 C or below (package surface temperature)
10 seconds or less
60 seconds or less
120 30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
PS2561-1,PS2561L-1,PS2561L1-1,PS2561L2-1
15