LQ150X1LGN2A Sharp Microelectronics, LQ150X1LGN2A Datasheet - Page 20

• Manufacturer Part Number: LQ150X1LGN2A
• Description: LCD TFT 15.0" 1024X768 XGA
• Manufacturer: Sharp Microelectronics

Specifications of LQ150X1LGN2A

• Display Type: LCD - Color
• Display Mode: *
• Viewing Area: 304.10mm L x 228.10mm W
• Dot Pixels: 1024 x 768 (XGA)
• Pixel Density: 1024 x 768
• Module Size (w X H X T): 326 mm x 252 mm x 11.5 mm
• Backlighting: White Normally White
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Interface: -
• Backlight: -
• Dot Size: -
• Dot Pitch: -
• Lead Free Status / Rohs Status: Details
• Other names: 425-2476

10. Handling Precautions
11. Packing form
a)
b)
c)
d)
e)
f)
g)
h)
i)
j)
k)
l)
a) Production country : JAPAN , TAIWAN, CHINA
b) Piling number of cartons : maximum 6 cartons
c) Packing quantity in one carton : 10 modules
d) Carton size : 408mm(W)×340mm(H)×398mm(D)
e) total mass of one carton filled with full modules : 12.0kg(typ.)
f) Packing form is shown in Fig.3
Be sure to turn off the power supply when inserting or disconnecting the cable.
Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or
twist.
Since the front polarize is easily damaged, pay attention not to scratch it.
Since long contact with water may cause discoloration or spots, wipe off water drop immediately.
When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with
care.
Since CMOS LSI is used in this module, take care of static electricity and take the human earth into
consideration when handling.
Make sure the four mounting holes of the module are grounded sufficiently. Take electro-magnetic
interference (EMI) into consideration.
The module has some printed circuit boards (PCBs) on the back side. Take care to keep them form any
stress or pressure when handling or installing the module; otherwise some of electronic parts on the PCBs
may be damaged.
Observe all other precautionary requirements in handling components.
When some pressure is added onto the module from rear side constantly, it causes display non-uniformity
issue, functional defect, etc. So, please avoid such design.
When handling LCD modules and assembling them into cabinets, please be noted that long-term
storage in the environment of oxidization or deoxidization gas and the use of such materials as reagent,
solvent, adhesive, resin, etc. which generate these gasses, may cause corrosion and discoloration of the
LCD modules.
LD-16823-17