P1TX4A-SX4-V-01 Omron, P1TX4A-SX4-V-01 Datasheet - Page 11

• Manufacturer Part Number: P1TX4A-SX4-V-01
• Description: FIBER OPTIC TRANS 4CH CWDM SC
• Manufacturer: Omron

Specifications of P1TX4A-SX4-V-01

• Product: Transmitter
• Data Rate: 1.65 Gbps
• Wavelength: 771.5 nm
• Maximum Operating Temperature: 70 C
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DVI / HDMI / FDDI
• Current - Supply: -
• Voltage - Supply: -
• Power - Output: -
• Applications: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: P1TX4ASX4V01; Z2549

Omron
ORIGINATOR:
B. Peters
OMRON
O
9.0
MRON
N
Mounting Configurations
Heat-sinking is critical to the life of the OSA, particularly the lasers. The
OSA should be mounted upside down and in direct contact with a
thermally conductive surface. The preferable surface is the main
product’s external metal housing, enabling heat transfer through the top of
the product to the ambient environment. The two recommended
configurations are:
9.1
9.2
One of the unique benefits of the SX4 is that the
ferrule is integrated into the OSA, eliminating the cost and complexity of a
fiber pigtail and a connector sleeve. To optimize use of this feature, the
OSA can be held in place by its wings and the ferrule via a clip, (example
shown). By applying upward pressure to the bottom of the clip, the OSA
will remain adequately seated for heat-sinking but still float to relieve any
mechanically induced stress when the fiber is connected. In such a
configuration, stress from the fiber (e.g. wiggle) will be transferred to the
wing and the product housing, not the optical
elements. We also strongly recommended placing a
thermal pad (shown in red above) between the OSA
and the heat-sink.
ETWORK
P
Top Connect
For those with space available on the CDR
board, the flex can be connected to the top
of the main CDR board via a ZIF connector
(e.g. Omron P/N XF2B-2745-31A).
Bottom-connect
For those with space constraints, the flex
circuit can be connected to the bottom of
the main board via the ZIF connector.
RODUCTS
SX4 Reference Design
®
LAST REVISED BY:
B. Peters 5/23/07
P1xX4A-SX4-01 Reference Designs Rev 2.4
DOCUMENT NO.
Main PCB
DOC00617
Wrap-around
Main PCB
APPROVED BY:
SHEET
Wrap-around Flex
Housing
Housing
11
Flex
OF
11
REV
2.4