MPDTY302S Murata Electronics North America, MPDTY302S Datasheet - Page 7

• Manufacturer Part Number: MPDTY302S
• Description: CONV DC/DC 17.5W .8-2.5VOUT SMT
• Manufacturer: Murata Electronics North America
• Series: MPDr
• Type: Point of Load (POL) Non-Isolated with UVLOr

Specifications of MPDTY302S

• Output: 0.8 ~ 2.5V
• Number Of Outputs: 1
• Power (watts): 17W
• Mounting Type: Surface Mount
• Voltage - Input: 3 ~ 3.6V
• Package / Case: 22-DIP SMD Module
• 1st Output: 0.8 ~ 2.5 VDC @ 7A
• Size / Dimension: 1.09" L x 0.61" W x 0.17" H (27.8mm x 15.4mm x 4.2mm)
• Power (watts) - Rated: 17.5W
• Operating Temperature: -40°C ~ 85°C
• Efficiency: 94%
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• Other names: 490-4573; 490-4573-1; 490-4573-1

8. Reliability
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
8.1 Humidity
8.2 Temperature Cycles
8.3 Vibration
8.4 Mechanical Shock
8.5 Solderability of Leads
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
specifications or transact the approval sheet for product specifications before ordering.
Note:
The side through-hole terminal will be immersed in the isopropyl alcohol (JIS-K-1522) with Rosin(JIS-K-5902)
solution (the concentration of Rosin will be allowed 10wt%~35wt%, and normally approx. 25wt% will be used
without any specific requirement.).
Then the terminal will be immersed in the solder H63A (JIS-Z-3282) solution at the tem-perature of 230℃±5℃
for 5±1 seconds, and pulled up completely. The solder will a-dhere to over three-quarter of the terminal.
According to JIS-C-0022.
40 土2°C, 90 to 95%RH, 100 hours. Leave for 4 hours at room temperature.
No damage in appearance and no deviation from electrical characteristics (section 6.1.).
Repeat cycle 5 times. Leave 2 hours at room temp.
No damage in appearance and no deviation from electrical characteristics (section 6.1.).
10 to 55Hz, 1.5mm amplitude (1minute cycle), 1 hour for each of X, Y, Z directions.
No damage in appearance and no deviation from electrical characteristics (section 6.1.).
20G, 1 time for each X, Y, Z directions.
No damage in appearance and no deviation from electrical characteristics (section 6.1.).
Step
1
2
3
4
Room Temp.
Room Temp.
+85°C±2°C
-40°C±3°C
Condition
5-10 minutes
5-10 minutes
30 minutes
30 minutes
Time
MPDTY301S,MPDTY302S DATA Sheet
2010.12.29
7