EVB-USB2514QFN48 SMSC, EVB-USB2514QFN48 Datasheet - Page 55

• Manufacturer Part Number: EVB-USB2514QFN48
• Description: BOARD EVAL FOR USB2514 48-QFN
• Manufacturer: SMSC

Specifications of EVB-USB2514QFN48

• Main Purpose: Interface, USB 2.0 Hub
• Embedded: No
• Utilized Ic / Part: USB2514, USB2514I
• Primary Attributes: Quad Port Hub, High Speed (480Mbps), I2C/SMBus
• Secondary Attributes: Overcurrent Protection, Port Power Switching, ESD Protection
• Interface Type: USB
• Product: Interface Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: USB2514
• Other names: EVB-USB2514GFN48; Q4128965

USB 2.0 Hi-Speed Hub Controller
Datasheet
SMSC USB251x
8.3.9
8.3.9.1
8.3.9.2
8.4
8.5
8.6
8.6.1
Normal
Internal Pull-Down
LED
Number
Part
SMBus Alert Response Address
The SMBALERT# signal is not supported by the hub.
Undefined Registers
The registers shown in
return 00h. Writes to undefined registers have no effect and do not return an error.
Reserved Registers
Reserved registers should be written to ‘0’ unless otherwise specified. Contents read should be
ignored.
To configure the SMSC hub in its default configuration, strap CFG_SEL[2:0] to 00h. This procedure
configures the hub to the internal defaults and enables the strapping options. Please see
"Internal Register Set (Common to EEPROM and SMBus)"
pin strapping options, please see
default values. Options include port disable and non-removable pin strapping.
The USB251x can be configured via a combination of internal default values and pin strap options.
Please see
The strapping option pins only cover a limited sub-set of the configuration options. The internal default
values will be used for the bits & registers that are not controlled by a strapping option pin. Please
refer to
Non-Removable Strap Option
The strap function of the NON_REM[x:0] pins are enabled through the internal default configuration.
The driver type of each strap pin is I/O (no internal pull-up or pull-down for the input function). Use
this type of strap option for NON_REM[1:0].
Low. Use the Strap High configuration to set the strap option value to a ‘1’. Use the Strap Low
configuration to set the strap option value to ‘0’.
Default Configuration Option
Default Strapping Options
Strap Options
Table 8.2
USB251x
USB251xi
USB251xA
USB251xAi
Table 8.2
for the internal default values that are loaded when this option is selected.
for specific details on how to enable the default/pin-strap configuration option.
Table 8.2
Table 8.7 Summary of Strap Options
USB251xB
USB251xBi
are the defined registers in the hub. Reads to undefined registers
Chapter 5, Pin Descriptions
DATASHEET
55
Resistor Value
47 - 100 kΩ
47 - 100 kΩ
Figure 8.3
10 kΩ
(R)
shows an example of Strap High and Strap
for the list of the default values. For specific
Only applicable to port power pins.
Contains a built-in resistor.
for instructions on how to modify the
Notes
Revision 1.1 (04-26-10)
Section 8.2.1,