STEVAL-MKI023V1 STMicroelectronics, STEVAL-MKI023V1 Datasheet - Page 11

• Manufacturer Part Number: STEVAL-MKI023V1
• Description: BOARD EVAL FOR LISY300AL
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI023V1

• Sensor Type: Gyroscope, 1 Axis
• Sensing Range: ±300°/sec
• Interface: Analog
• Sensitivity: 3.3 mV/°/s
• Voltage - Supply: 2.7 V ~ 3.6 V
• Embedded: No
• Utilized Ic / Part: LISY300AL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8504

UM0701
5.1.4
The CN13-4-pin of the STM3210B-EVAL is also used by the Tamper button. The Tamper
button cannot be used when using the Int2 signal.
Figure 7.
Setup for digital MEMS - I
Position the JP7 and JP12 jumpers on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14-pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
The CN13-4-pin of the STM3210B-EVAL is also used by the Tamper button. The Tamper
button cannot be used when using the Int2 signal.
Figure 8.
Setup for digital MEMS - SPI interface
Setup for digital MEMS - I
Doc ID 15703 Rev 1
2
C interface
2
C interface
System setup
11/42