STEVAL-ICB002V1 STMicroelectronics, STEVAL-ICB002V1 Datasheet - Page 13

• Manufacturer Part Number: STEVAL-ICB002V1
• Description: BOARD EVAL TOUCH STM32/STMPE821
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ICB002V1

• Sensor Type: Touch, Capacitive
• Sensing Range: 3 Button/Key
• Interface: USB
• Voltage - Supply: 3.3V
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: STMPE821
• Silicon Manufacturer: STMicroelectronics
• Kit Contents: Board
• Features: PWM/GPIO Output, Multiple Touch Detection, Demonstrates Up To 3 Capacitive Touch Keys
• Svhc: No SVHC (15-Dec-2010)
• For Use With: 497-10173 - BOARD EVAL S-TOUCH STM32
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Sensitivity: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-10167

STMPE821
Table 4.
Figure 6.
More than one byte
More than one byte
Mode
Read
Write
One byte
One byte
Read
Read
Read
Write
Operation modes
Read and write modes (random and sequential)
Byte
Address
Address
Address
Address
Master
Device
Slave
Device
Device
Device
≥1
≥1
Start, Device address, R/W = 0, Register address to be read
Restart, Device address, R/W = 1, Data Read, STOP
If no Stop is issued, the Data Read can be continuously performed. If
the register address falls within the range that allows an address auto-
increment, then the register address auto-increments internally after
every byte of data being read. For those register addresses that fall
within a non-incremental address range, the address will be kept static
throughout the entire write operations. Refer to the memory map table
for the address ranges that are auto and non-increment. An example
of such a non-increment address is FIFO
Start, Device address, R/W = 0, Register address to be written, Data
Write, Stop
If no Stop is issued, the Data Write can be continuously performed. If
the register address falls within the range that allows address auto-
increment, then the register address auto-increments internally after
every byte of data being written in. For those register addresses that
fall within a non-incremental address range, the address will be kept
static throughout the entire write operations. Refer to the memory map
table for the address ranges that are auto and non-increment. An
example of a non-increment address is Data port for initializing the
PWM commands.
Doc ID 14478 Rev 5
Address
Address
Address
Address
Reg
Reg
Reg
Reg
Data to
written
Write
to be
Data
Address
Address
Device
Device
Programming sequence
Write + 1
Data to
Read
Read
Data
Data
Write + 2
Data to
Read + 1
Data
Read + 2
I2C interface
Data
13/50