DK-CYCII-2C20N Altera, DK-CYCII-2C20N Datasheet - Page 19

• Manufacturer Part Number: DK-CYCII-2C20N
• Description: CYCLONE II STARTER KIT EP2C20N
• Manufacturer: Altera
• Series: Cyclone® IIr
• Type: FPGAr

Specifications of DK-CYCII-2C20N

• Contents: Dev Board, Quartus®II Web Edition, Nios®II Web Edition, Cables, Accessories, Reference Designs and Demos
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Cyclone
• Silicon Core Number: EP2C
• Silicon Family Name: Cyclone II
• Rohs Compliant: Yes
• For Use With/related Products: Cyclone®II FPGAs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-1736

Requirements
Hardware Setup
FPGA
Configuration
Altera Corporation
October 2006
The development kit includes a Control Panel facility that enables a user
to access various components on the development board from a host
computer through a USB connection. For an overview of the Control
Panel and its use, refer to
Setting up the Control Panel involves the following actions:
■
■
■
Preparation for setting up and using the Control Panel requires the
following prerequisite actions:
■
■
Ensure that the development board has powered up and is operating
normally, as described in
board is not powered up, but has already been set up and its operation
verified, perform the following steps:
1.
2.
3.
4.
Before using the Control Panel, configure a corresponding circuit in the
Cyclone II FPGA by downloading the CII_Starter_USB_API.sof
configuration file from the
Set up the hardware
Configure the FPGA
Start the Control Panel
Install the Altera USB-Blaster driver software on the host computer,
if not already installed
Install the Altera Quartus
already installed
Check that the USB-Blaster cable connects the host computer to the
the development board.
Check that the 7.5 V DC adapter connects the development board to
a power source.
Set the RUN/PROG switch to the RUN position.
Turn the power on by depressing the ON/OFF switch on the
development board.
“Development Board Setup” on page
“Using the Control Panel”
3. Control Panel Setup
®
software on the host computer, if not
chapter.
2–1. If the
3–1