STM8/128-EVAL STMicroelectronics, STM8/128-EVAL Datasheet - Page 53

• Manufacturer Part Number: STM8/128-EVAL
• Description: BOARD EVAL FOR STM8S
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM8/128-EVAL

• Mfg Application Notes: STM8S Getting Started
• Contents: Evaluation Board
• Silicon Manufacturer: ST Micro
• Core Architecture: STM8
• Core Sub-architecture: STM8
• Silicon Core Number: STM8
• Silicon Family Name: STM8S2xx
• Kit Contents: Board
• For Use With/related Products: STM8S2xx
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8506

STM8S207xx, STM8S208xx
10
10.1
10.1.1
10.1.2
10.1.3
10.1.4
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean ± 3 ).
Typical values
Unless otherwise specified, typical data are based on T
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 )
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Typical current consumption
For typical current consumption measurements, V
together in the configuration shown in
Figure 9.
Supply current measurement conditions
5 V or 3.3 V
Doc ID 14733 Rev 11
A
Figure
9.
DD
V
V
V
V
V
V
DD
DDA
DDIO
SS
SSA
SSIO
, V
A
A
DDIO
SS
= 25 °C and T
= 25 °C, V
.
.
and V
Electrical characteristics
DDA
DD
= 5 V. They are given
A
are connected
= T
Amax
(given by
53/105