EM2XX-ISA-R Ember, EM2XX-ISA-R Datasheet - Page 6

• Manufacturer Part Number: EM2XX-ISA-R
• Description: INSIGHT ADAPTER FOR EM2XX
• Manufacturer: Ember
• Series: InSightr
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of EM2XX-ISA-R

• Contents: Board, Cables, Power Supply
• For Use With/related Products: EM2xx
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 636-1029

Insight Adapter Technical Specification
Figure 2. InSight Adapter back panel
Back Panel Interfaces
Figure 2 contains three PC-based interfaces (a USB connector, an RJ-45 connector, and
a DC power jack) and one LED indicator. The LED indicator (blue) illuminates when
valid power is connected to the InSight Adapter. The InSight Adapter can be powered
either by the 12V DC jack (J3) or by Power-over-Ethernet. Therefore, the InSight
Adapter ships with a 12V DC power supply with appropriate AC plugs for your region,
while the EM2xx Kit ships with a Power-over-Ethernet injector.
DC Power Jack
The DC power jack on the InSight Adapter allows for a robust connection (5000 cycles)
to the 12V DC power supply provided. The 2.1 x 5.5mm jack from CUI, Inc (MFG P/N:
PJ-105A-SMT) is rated to 16V DC at 2.5A. The center pin of the jack is +V with shroud
connected to the GND plane. If you want to use a different DC power supply, contact
Ember Support ([e-mail]).
RJ-45 Connector
The RJ-45 is a 10-pin surface-mount interface for a standard Cat5 cable. It provides
access to the Ethernet backchannel via 10/100 Ethernet link. The connector also
provides for a 48V interface from the Ember Developer Kit’s Power-over-Ethernet
injector. The connector on the InSight Adapter integrates the Link and Activity LEDs for
an immediate feedback for proper installation.
USB
The USB connector (USB-B type) is used only for administration and configuration of the
InSight Adapter. A standard 4-foot USB cable (USB-B to USB-A) ships with the InSight
Adapter; however, you can use any USB cable. For more information on configuration
and administration commands, refer to the EM250 User Guide (120-4024-000).
LED Power Indicator
The blue LED on the back panel illuminates when valid power is connected to the
InSight Adapter. This LED should stay lit—but not blinking—during normal operation. If
the LED blinks, disconnect power and contact Ember Support ([e-mail]).
Note:
same time. Logic in the InSight Adapter gives priority to the DC power supply.
PoE and a DC power supply can be connected to the InSight Adapter at the
100M
Link
12V DC
00:0d:6f:12:34:56
MAC Address:
120-2002-000G
Power
Page 6