FS2009(UN) Equinox Technologies, FS2009(UN) Datasheet - Page 5

• Manufacturer Part Number: FS2009(UN)
• Description: PORTABLE PRODUCTION ISP HS USB
• Manufacturer: Equinox Technologies
• Series: FS2009r
• Type: Portable Production ISPr

Specifications of FS2009(UN)

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: Programmer, In-Circuit
• Supported Families: AVR, ATtiny, AT89S
• Features: Supports Standalone Operation, Robust I/O Driver Stage, Very Fast Programming Speed
• Rohs Compliant: Yes
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1020

Equinox Products Page - FS2009 - Portable high-speed multi-project USB In-System (ISP) Programmer - ...
http://www.equinox-tech.com/products/details.asp?ID=1303
programmer SCK2 pin.
This clock frequncy could be used for the following purposes:
The FS2009 is a CE / FCC and RoHS approved product.
The FS2009 supports fast programming of Target Devices via the SPI, JTAG and UART algorithms.
The programmer is capable of performing a multi-project Programming Sequence in Standalone
Mode as follows:
This powerful functionality allows the programmer to be used as part of an In-Circuit Test procedure
where the Target Firmware must be allowed to execute in order to eg. calculate some calibration
values. The programmer initially programs some 'Test Firmware' into the Target Device and then
allows the Target to run this firmware and waits for this firmware to finish executing. The real
'Production Firmware' is then programmed into the Target Device.
This product supports devices from the manufacturers listed below:
Atmel Corporation
Dallas Semiconductor (Maxim)
Exel Semiconductor (Rohm)
Holtek Semiconductor
IC Microsystems
ISSI
Microchip
NXP (Philips)
ON Semiconductors (Catalyst)
Ramtron
Rohm
Seiko Instruments
STMicroelectronics
Xicor
Zensys
The following are available as chargeable upgrades: JTAG In-System Programming support for
the Atmel ATmega AVR Family; 24Cxxx - Serial I2C EEPROM Memory Device Library and Atmel
AT91SAM7 Upgrade Pack. See [Upgrades] tab.
Please note:
Not all devices may be supported within a family.
Spare Programmer I/O pins
CE / FCC Approved Product
Fast Programming Times
Standalone Mode - Program -> Test -> Re-Program
Device Support (by manufacturer)
To toggle the STROBE pin on a Watchdog Timer IC to stop the IC from timing out during the
In-System Programming operation.
To provide a clock to an Atmel ATmega microcontroller to resurrect a device which has an
incorrectly configured Internal Oscillator.
In SPI mode, there are 2 x Spare I/O pins for custom use
In UART mode, there is 1 x Spare I/O pins for custom use
The spare I/O pin(s) can be used for controlling circuitry on the user Target System including
Chip Selects, additional RESET control lines, Watchdog Timers etc.
Program Test Firmware
Execute Target Firmware
Wait for Target Firmware to finish
Program Production Firmware
Page 5 of 7
2/17/2009