STICE-SYS001 STMicroelectronics, STICE-SYS001 Datasheet - Page 11

• Manufacturer Part Number: STICE-SYS001
• Description: EMULATOR FOR STM8
• Manufacturer: STMicroelectronics
• Series: STM8r
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of STICE-SYS001

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: STM8
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10029

UM0406
2.3
Quick setup for in-circuit programming/debugging
Figure 4.
1.
2.
3.
4.
5.
6.
Install STVD on your host PC from the provided CD-ROM.
Check the STice power switch is off, then connect the power supply.
Connect the USB cable to STice and to your host PC. Your PC automatically identifies
the new hardware when the STice is powered on.
For an STM8 microcontroller using the SWIM protocol:
a)
b)
c)
Connect your application board’s power supply.
Power up your emulator, then your application board.
Connect the SWIM connector board to the STice ICD/ICP port.
Connect the SWIM cable to the SWIM connector board.
Connect the SWIM cable to the ERNI connector on the application board where
your microcontroller is installed. Information about the SWIM connection for
ICD/ICP is provided in
Connection for ICD/ICP
2
Doc ID 13332 Rev 3
3
Section 4.2 on page
1
19.
4
5
STice
right panel
/ICP
Getting started
11/26