ZK-HC08AX-A SofTec Microsystems SRL, ZK-HC08AX-A Datasheet - Page 5

• Manufacturer Part Number: ZK-HC08AX-A
• Description: KIT STARTER FOR MC68HC908AB/S/Z
• Manufacturer: SofTec Microsystems SRL
• Type: MCUr

Specifications of ZK-HC08AX-A

• Contents: Board, Cable, Software, Datasheets and User Manual
• For Use With/related Products: Freescale MC68HC908AB/ AS/ AZ (64-QFP ZIF Socket)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 520-1033

3. Summary of Jumper and Connector Settings
Using the “MON08” Connector
When using the “MON08” connector, the RST_IN# and RST_OUT#
signals in the “RST_IN#/RST_OUT#” connector coincide with the
microcontroller’s RST# signal.
Using the Built-In USB to MON08 Interface
When using the built-In USB to MON08 Interface, the RST_IN# and
RST_OUT# signals in the “RST_IN#/RST_OUT#” connector coincide
with the microcontroller’s RST# signal.
Jumpers Summary
Name
J106
J108
J109
J111
J201
J202
debugger/programmer to the target system: it can be GND or open
drain.
The RST_IN# signal is the reset signal generated by your target
application: it is adapted by the external in-circuit
debugger/programmer which properly drives the microcontroller’s
RST# line.
Reference
1
1
2
3
1
2
3
1
Description/Pinout
VREFH SELECTION
1-2 (USER)
2-3 (VDD)
EMON08 CONNECTOR
Installed
Not Installed
OSC SEL
1-2 (CLOCK)
2-3 (CRYSTAL)
PTG0 PUSH-BUTTON ENABLE
Installed
Not Installed
PTG1 PUSH-BUTTON ENABLE
Installed
Not Installed
ZK-HC08-AX-A User's Manual
VREFH connected to the J104
connector
VREFH tied to VDD (default)
When using the built-in USB to
MON08 interface or an external
in-circuit debugger/programmer
connected to the “MON08”
connector (default)
When using an external in-circuit
debugger/programmer connected to
this connector
Clock selected
Crystal configuration selected
(default)
The PTG0 push-button is
connected to the
microcontroller’s PTG0 pin
(default)
The PTG0 push-button is not
connected to the microcontroller
The PTG1 push-button is
connected to the
microcontroller’s PTG1 pin
(default)
The PTG1 push-button is not
connected to the microcontroller
Page 5