CCV-084B16 CUI Inc, CCV-084B16 Datasheet - Page 3

• Manufacturer Part Number: CCV-084B16
• Description: BUZZER AUDIO MAGNETIC 3.6VDC SMD
• Manufacturer: CUI Inc
• Type: Magnetic Transducer, External Driver

Specifications of CCV-084B16

• Frequency: 2.73kHz
• Voltage - Rated: 3.6Vo-p
• Current Rating: 110mA
• Size / Dimension: Circular - 9mm Dia x 2.5mm H
• Mounting Type: Surface Mount
• Sound Pressure Level: 85dB
• Operating Mode: Continuous
• Voltage Range: 2.5 ~ 4.5Vo-p
• Termination: Solder Pads
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Frequency: -
• Other names: 102-1265-2

PART NUMBER: CCV-084B16
MECHANICAL CHARACTERISTICS
item
solderability
soldering heat resistance
terminal mechanical strength
vibration
drop test
ENVIRONMENT TEST
item
high temp. test
low temp. test
thermal shock
temp. cycle test
20050 SW 112
th
Ave. Tualatin, Oregon 97062
test condition
Lead terminals are immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
The product is followed the reflow temperature
curve to test its reflow thermo stability.
Lead pads shall be soldered on the pc board,
and a force of 9.8N (1.0kg) shall be applied
behind the part for 10 seconds.
The buzzer shall be measured after applying
a vibration amplitude of 1.5 mm with 10 to
55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part will be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axes (X, Y, Z) for a total of 9 drops.
test condition
After being placed in a chamber at +85°C for
96 hours.
After being placed in a chamber at -40°C for
96 hours.
The part shall be subjected to 10 cycles. One
cycle will consist of:
The part shall be subjected to 5 cycles. One
cycle will consist of:
phone
phone [phone] fax
DESCRIPTION: magnetic buzzer
fax [phone]
evaluation standard
evaluation standard
No damage or cutting off.
The buzzer will be measured after
95% min. of the lead terminals
will be wet with solder.
No interference in operation.
The value of oscillation
frequency/current consumption
should be ±10% of the initial
measurements. The SPL should
be within ±10dB compared with
the initial measurement.
being placed at +25°C for 4
hours. The value of the
oscillation frequency/current
consumption should be ±10%
compared to the initial
measurements. The SPL should
be within ±10dB compared to the
initial measurements.
page
date
03/2008
3 of 5