RP34L-5R-2PD Hirose Electric Co Ltd, RP34L-5R-2PD Datasheet - Page 6

• Manufacturer Part Number: RP34L-5R-2PD
• Description: CONN RECEPT POWR SUPPLY 2POS
• Manufacturer: Hirose Electric Co Ltd
• Series: RP34Lr

Specifications of RP34L-5R-2PD

• Contact Type: Male Pin
• Connector Type: Header, Shrouded
• Number Of Positions: 2
• Number Of Positions Loaded: All
• Number Of Rows: 1
• Mounting Type: Through Hole
• Termination: Solder
• Features: Board Guide
• Contact Finish: Palladium
• Color: Black
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Contact Finish Thickness: -
• Pitch: -
• Row Spacing: -
• Fastening Type: -
• Contact Mating Length: -
• Other names: *RP34L-5R-2PD; H2348

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
6
Straight Plug
Right Angle Plug
Assembly Instructions(3-Position Plug)
Outer case
Insulator body
Outer case
Outer case
Outer case
Outer case
Insulator body
1. Slide the bushing over the cable.
2. Prepare the cable end and the conductors as shown.
3. Crimp the contacts to each conductor.
4. Insert each of the contacts into the insulator body.
5. Crimp the cable clamp over the cable at designated
6. Place the outer case on a flat surface , with inside facing up.
7. Carefully place the insulator body, clamp and the bushing
Note A: When placing all components in the case,
Note B: All components should fit easily, without use of
8. Carefully align the other outer case over all
9. Snap the case in place.
1. The right angle plug can also be assembled by
Verify that the contact is secure by slightly pulling
on the conductor. Should the contacts require re-
insertion, use the tool RP6-SC-TP to remove them
(Inserted from the termination side).
dimension (Tool number:RP34-TC-01).
into corresponding indents and cut-outs in the outer case.
components case. Do not force alignment.
using the same procedure as the straight plug.
Verify the crimp dimensions.
Verify correct location. (As shown on drawing)
exercise caution as NOT to damage any of the
protruding snap.
any force.