SMD Inductors(Coils)
For Signal Line(Multilayer, Magnetic Shielded)
MLF Series MLF1005
Various kinds of digital equipment are becoming smaller with more
advanced functions. Therefore, parts used in such digital
equipment need to be small and thinner.
MLFI005 Series inductors were developed to meet these
demands. This series of inductors have 75% less mass than
conventional MLF1608 inductors and are magnetically sealed just
like conventional inductors, making high-density mounting
possible.
FEATURES
• 75% less mass than the MLF1608 series.
• Magnetically sealed configuration allowing for high-density
• Does not contain lead and is compatible with lead-free
• It is a product conforming to RoHS directive.
APPLICATIONS
Signal processing modules such as mobile phones and tuners
SPECIFICATIONS
Operating temperature range
Storage temperature range
RECOMMENDED SOLDERING CONDITION
REFLOW SOLDERING
• Conformity to RoHS Directive: This means that, in conformity with EU Directive 2002/95/EC, lead, cadmium, mercury, hexavalent chromium, and specific
• Please contact our Sales office when your application are considered the following:
• All specifications are subject to change without notice.
250 to 260˚C
230˚C
180˚C
150˚C
The device’s failure or malfunction may directly endanger human life (e.g. application for automobile/aircraft/medical/nuclear power devices, etc.)
bromine-based flame retardants, PBB and PBDE, have not been used, except for exempted applications.
mounting.
soldering.
Preheating
60 to 120s
Time(s)
Soldering
30 to 60s
10s max.
–40 to +85°C
–40 to +85°C
Natural
cooling
PRODUCT IDENTIFICATION
(1) Series name
(2) Dimensions L× W
(3) Material code
(4) Inductance value
(5) Inductance tolerance
(6) Packaging style
PACKAGING STYLE AND QUANTITIES
Packaging style
Taping
HANDLING AND PRECAUTIONS
• Before soldering, be sure to preheat components.
• After mounting components onto the printed circuit board, do not
• The inductance value may change due to magnetic saturation if
• Do not expose the inductors to stray magnetic fields.
• Avoid static electricity discharge during handling.
• When hand soldering, apply the soldering iron to the printed cir-
MLF 1005 DR10 K
(1)
The preheating temperature should be set so that the tempera-
ture difference between the solder temperature and product
temperature does not exceed 150°C.
apply stress through board bending or mishandling.
the current exceeds the rated maximum.
cuit board only. Temperature of the iron tip should not exceed
350°C. Soldering time should not exceed 3 seconds.
1005
R10
1R0
K
T
(2)
(3)
(4) (5)
T
Quantity
10000 pieces/reel
002-04 / 20090402 / e511_mlf1005.fm
Taping [reel]
1.0× 0.5× 0.5
0.1µH
1.0µH
±10%
Conformity to RoHS Directive
(1/3)