B82422T1473K EPCOS Inc, B82422T1473K Datasheet - Page 11

• Manufacturer Part Number: B82422T1473K
• Description: INDUCTOR 47UH 60MA 1210 10%
• Manufacturer: EPCOS Inc
• Series: SIMIDr
• Type: Ferrite Corer

Specifications of B82422T1473K

• Inductance: 47µH
• Tolerance: ±10%
• Package / Case: 1210 (3225 Metric)
• Current: 60mA
• Dc Resistance (dcr): 7 Ohm Max
• Q @ Freq: 27 @ 2.52MHz
• Self Resonant Freq: 15MHz
• Mounting Type: Surface Mount
• Frequency - Test: 2.52MHz
• Material - Core: Ferrite
• Applications: General Purpose
• Core Material: Ferrite
• Dimensions: 2.5 mm W x 3.2 mm L x 2.1 mm H
• Shielding: Unshielded
• Test Frequency: 2.52 MHz
• Maximum Dc Current: 60 mAmps
• Maximum Dc Resistance: 7 Ohms
• Self Resonant Frequency: 15 MHz
• Q Minimum: 27
• Termination Style: SMD/SMT
• Inductance Tolerance: ± 10%
• Dc Resistance Max: 7ohm
• Dc Current Rating: 60mA
• Q Test Frequency: 2.52MHz
• Inductor Case Style: 1210
• No. Of Pins: 2
• Svhc: No SVHC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Saturation: -
• Current - Temperature Rise: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 495-1738-2; B82422T1473K000

An interference source which is at a floating potential primarily emits differential-mode, i.e. symmet-
rical interference which is propagated along the connected lines. On power lines, the interference
current will flow towards the disturbed equipment on one wire and away from it on the other wire,
just as the mains current does.
Symmetrical or differential-mode interference occurs mainly at low frequencies (up to several
hundred kHz).
However, parasitic capacitances in interference sources and disturbed equipment or intended
ground connections, also lead to an interference current in the ground circuit. This interference cur-
rent flows towards the disturbed equipment through both the connecting lines and returns to the in-
terference source through the ground lines.The currents on the connecting lines are in common
mode and the interference is thus designated as common-mode or asymmetrical interference.
Since the parasitic capacitances will tend towards representing a short-circuit with increasing fre-
quencies and the coupling to the connecting cables and the equipment itself will increase corre-
spondingly, common-mode interference becomes dominant at multiple-MHz frequencies.
In European usage, the concept of an “unsymmetrical interference” is used, in addition to the two
components described above, to describe interference. This term is used to describe the interfer-
ence voltage between a line and reference ground potential.
2.6
Interference suppression filters are virtually always designed as reflecting lowpass filters, i.e. they
reach their highest insertion loss when they are - on the one hand - mismatched to the impedance
of the interference source or disturbed equipment and - on the other hand - mismatched to the im-
pedance of the line. Possible filter circuits for various line, interference source and disturbed equip-
ment impedance conditions are shown in
Line
impedance
low
high
high
unknown
low
low
unknown
Fig. 9
General Technical Information
Filter circuits and line impedance
Filter circuits and impedance relationships
Impedance of
source of interference / disturbed equipment
high
high
high
unknown
low
low
unknown
fig.
9.
19
04/00