DSPIC30F4013T-20E/PT Microchip Technology, DSPIC30F4013T-20E/PT Datasheet - Page 3

• Manufacturer Part Number: DSPIC30F4013T-20E/PT
• Description: IC DSPIC MCU/DSP 48K 44TQFP
• Manufacturer: Microchip Technology
• Series: dsPIC™ 30Fr

Specifications of DSPIC30F4013T-20E/PT

• Core Processor: dsPIC
• Core Size: 16-Bit
• Speed: 20 MIPS
• Connectivity: CAN, I²C, SPI, UART/USART
• Peripherals: AC'97, Brown-out Detect/Reset, I²S, POR, PWM, WDT
• Number Of I /o: 30
• Program Memory Size: 48KB (16K x 24)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 13x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 44-TQFP, 44-VQFP
• For Use With: AC30F006 - MODULE SKT FOR DSPIC30F 44TQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: DSPIC30F4013T20EP

1. Module: MAC Class Instructions with ±4
© 2008 Microchip Technology Inc.
Sequential MAC class instructions, which prefetch
data from Y data space using ±4 address
modification, will cause an address error trap. The
trap occurs only when all the following conditions
are true:
1. Two sequential MAC class instructions (or a
2. Both instructions prefetch data from Y data
3. Neither of the instruction uses an accumulator
Work around
The problem described above can be avoided by
using any of the following methods:
1. Inserting any other instruction between the two
2. Adding an accumulator write back (a dummy
3. Do not use the + = 4 or - = 4 address
4. Do not prefetch data from Y data space.
MAC class instruction executed in a REPEAT or
DO loop) that prefetch from Y data space.
space using the + = 4 or - = 4 address
modification.
write back.
MAC class instructions.
write back if needed) to either of the MAC class
instructions.
modification.
Address Modification
2. Module: CPU –
EXAMPLE 1:
L0:DAW.b
L1: ....
dsPIC30F3014/4013
The Decimal Adjust instruction, DAW.b, may
improperly clear the Carry bit, C (SR<0>), when
executed.
Work around
Check the state of the Carry bit prior to executing
the DAW.b instruction. If the Carry bit is set, set the
Carry bit again after executing the DAW.b
instruction. Example 1 shows how the application
should process the Carry bit during a BCD addition
operation.
.include “p30f5013.inc”
.......
MOV.b
MOV.b
ADD.b
BRA
DAW.b
BSET.b
BRA
#0x80, w0
#0x80, w1
w0, w1, w2 ;Perform addition
NC, L0
w2
L1
w2
SR, #C
CHECK CARRY BIT BEFORE
DAW.b
DAW.b
;First BCD number
;Second BCD number
;If C set go to L0
;If not,do DAW and
;set the carry bit
;and exit
Instruction
DS80397A-page 3