Z86E3116VSC Zilog, Z86E3116VSC Datasheet - Page 30

• Manufacturer Part Number: Z86E3116VSC
• Description: IC MICROCONTROLLER 2K 28-PLCC
• Manufacturer: Zilog
• Series: Z8®r

Specifications of Z86E3116VSC

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 16MHz
• Peripherals: POR, WDT
• Number Of I /o: 24
• Program Memory Size: 2KB (2K x 8)
• Program Memory Type: OTP
• Ram Size: 125 x 8
• Voltage - Supply (vcc/vdd): 3.5 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 28-PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Connectivity: -
• Other names: 269-1057; 269-1057

PIN FUNCTIONS (Continued)
Z86E30/E31/E40
Z8 4K OTP Microcontroller
Comparator Inputs. Port 3, P31, and P32, each have a
comparator front end. The comparator reference voltage
P33 is common to both comparators. In analog mode, P31
and P32 are the positive input of the comparators and P33
is the reference voltage of the comparators.
Auto Latch. The Auto Latch puts valid CMOS levels on all
CMOS inputs (except P33–P31) that are not externally
driven. Whether this level is 0 or 1, cannot be determined.
A valid CMOS level, rather than a floating node, reduces
excessive supply current flow in the input buffer. Auto
Latches are available on Port 0, Port 2, and P30. There
are no Auto Latches on P31, P32, and P33.
Low EMI Emission. The Z86E40 can be programmed to
operate in a low EMI Emission Mode in the PCON register.
The oscillator and all I/O ports can be programmed as low
EMI emission mode independently. Use of this feature re-
sults in:
30
P R E L I M I N A R Y
The pre-drivers slew rate reduced to 10 ns typical.
Low EMI output drivers have resistance of 200 Ohms
(typical).
Low EMI Oscillator.
Internal SCLK/TCLK= XTAL operation limited to a
maximum of 4 MHz – 250 ns cycle time, when Low EMI
Oscillator is selected and system clock (SCLK = XTAL,
SMR Reg. Bit D1 =1).
Note for emulation only:
Do not set the emulator to emulate Port 1 in low EMI
mode. Port 1 must always be configured in Standard
Mode.
DS97Z8X0502
Zilog