CAT1025ZI-30-GT3 ON Semiconductor, CAT1025ZI-30-GT3 Datasheet - Page 10

• Manufacturer Part Number: CAT1025ZI-30-GT3
• Description: IC SUPERVISOR CPU 2K EEPR 8MSOP
• Manufacturer: ON Semiconductor
• Type: Simple Reset/Power-On Resetr

Specifications of CAT1025ZI-30-GT3

• Number Of Voltages Monitored: 1
• Output: Open Drain or Open Collector
• Reset: Active High/Active Low
• Reset Timeout: 130 ms Minimum
• Voltage - Threshold: 3V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-MSOP, Micro8™, 8-uMAX, 8-uSOP,
• Undervoltage Threshold: 3 V to 3.15 V
• Output Type: Open Collector / Drain
• Manual Reset: Resettable
• Watchdog: Watchdog
• Power-up Reset Delay (typ): 5 us
• Supply Voltage (max): + 7 V
• Supply Voltage (min): - 2 V
• Supply Current (typ): - 2 uA to + 10 uA
• Maximum Power Dissipation: 1 W
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Power Fail Detection: No
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CAT1024, CAT1025
ACKNOWLEDGE
After a successful data transfer, each receiving
device is required to generate an acknowledge. The
acknowledging device pulls down the SDA line
during the ninth clock cycle, signaling that it received
the 8 bits of data.
The CAT1024/25 responds with an acknowledge
after receiving a START condition and its slave
address. If the device has been selected along with
a write operation, it responds with an acknowledge
after receiving each 8-bit byte.
When the CAT1024/25 begins a READ mode it
transmits 8 bits of data, releases the SDA line and
monitors the line for an acknowledge. Once it
receives this acknowledge, the CAT1024/25 will
continue to transmit data. If no acknowledge is sent
by the Master, the device terminates data transmis–
sion and waits for a STOP condition.
Figure 5. Start/Stop Timing
Figure 6. Acknowledge Timing
Figure 7: Slave Address Bits
Doc. No. MD-3008 Rev. R
FROM TRANSMITTER
FROM RECEIVER
SDA
SCL
DATA OUTPUT
DATA OUTPUT
SCL FROM
Default Configuration
MASTER
START BIT
START
1
1
0
10
1
WRITE OPERATIONS
Byte Write
In the Byte Write mode, the Master device sends the
START condition and the slave address information
(with the R/W ¯ ¯ bit set to zero) to the Slave device. After
the Slave generates an acknowledge, the Master sends
a 8-bit address that is to be written into the address
pointers of the device. After receiving another acknow-
ledge from the Slave, the Master device transmits the
data to be written into the addressed memory location.
The CAT1024/25 acknowledges once more and the
Master generates the STOP condition. At this time, the
device begins an internal programming cycle to non-
volatile memory. While the cycle is in progress,
the device will not respond to any request from the
Master device.
0
0
8
0
STOP BIT
ACKNOWLEDGE
0
R/W
9
Characteristics subject to change without notice
© 2009 SCILLC. All rights reserved.