SC560DULTRT Semtech, SC560DULTRT Datasheet - Page 10

• Manufacturer Part Number: SC560DULTRT
• Description: IC LDO REG DUAL-OUT LN 8-MLPQ
• Manufacturer: Semtech

Specifications of SC560DULTRT

• Regulator Topology: Positive Fixed
• Voltage - Output: 2.8V, 1.8V
• Voltage - Input: 2.5 ~ 5.5 V
• Voltage - Dropout (typical): 0.1V @ 200mA
• Number Of Regulators: 2
• Current - Output: 300mA
• Current - Limit (min): 350mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-MLPQ
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: SC560DULTR

Applications Information
General Description
The SC560 is a family of dual output linear regulator devices
intended for applications where low dropout voltage, low
supply current, and low output noise are critical. Each
device provides a very simple, low cost solution for two
separate regulated outputs. Very little PCB area is required
due to the miniature package size and the need for only
four external capacitors.
The linear regulators LDOA and LDOB are powered from
a single input supply rail, and each provides 300mA of
output current. The SC560 can provide output voltages
in the range 1.2V to 5.0V. The output voltages for the
SC560A, SC560B and SC560C are set by connecting
external resistor dividers to the feedback pins of each
LDO. All other versions of the SC560 have fi xed output
voltage values shown in the Pinout and Voltage Options
table.
Power On Control
The SC560A and SC560C devices have a single enable pin
(EN) that controls both LDO outputs. Pulling this pin low
causes the device to enter a low power shutdown mode
where it typically draws 100nA from the input supply.
When EN transitions high, the output of LDOA is enabled.
After a delay of 128μs, the output of LDOB is enabled. In
the SC560C, when the output voltage of LDOA reaches
87% of its regulation point, the delay timer starts and the
PGOOD signal transitions high after a delay of 200ms. The
power up/down sequence is shown in the timing diagram
in Figure 1.
PGOOD
OUTA
OUTB
EN
Figure 1 — Timing Diagram
128 μs
87%
200ms
87%
The SC560B and the fi xed output variants provide
a separate enable pin for LDOB which allows LDOA
and LDOB to be enabled independently. The EN pin
controls the LDOA output and the ENB provides the
same functionality relative to the LDOB output. The
table shown below lists the eff ect of the polarity of the
EN and ENB signals on the outputs of LDOA and LDOB.
Since LDOB can be enabled separately, there is no timing
relationship between the two outputs at startup.
The SC560C and the fi xed output variants have a PGOOD
signal which monitors the output of LDOA and transitions
high 200ms after LDOA has reached 87% of its regulation
point. This can be used to hold a processor in reset when
the output voltage is out of regulation.
Output Voltage Selection
The output voltage of each LDO for the SC560A, SC560B,
and SC560C version is set independently using external
resistor dividers. Figure 2 illustrates the proper connection
for LDOA.
Figure 2 — Output Voltage Feedback Circuit
High
High
Low
Low
EN
R
R
1
2
ENB
High
High
Low
Low
OUTA
LDOA
Off
Off
On
On
FBA
LDOB
Off
Off
Off
On
SC560
10