CN1210L8G EPCOS Inc, CN1210L8G Datasheet - Page 79

• Manufacturer Part Number: CN1210L8G
• Description: VARISTOR 8VRMS 1210 SMD
• Manufacturer: EPCOS Inc
• Series: CN Standardr

Specifications of CN1210L8G

• Varistor Voltage: 15V
• Current-surge: 400A
• Number Of Circuits: 1
• Maximum Ac Volts: 8VAC
• Maximum Dc Volts: 11VDC
• Energy: 1.0J
• Package / Case: 1210 (3225 Metric)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: B72530V 80L 62; B72530V0080L062; B72530V80L62

Storage
Handling
Mounting
Soldering
Please read Cautions and warnings and
Important notes at the end of this document.
Multilayer varistors (MLVs)
Standard series
Specified values only apply to CTVS components that have not been subject to prior electrical,
mechanical or thermal damage. The use of CTVS devices in line-to-ground applications is
therefore not advisable, and it is only allowed together with safety countermeasures like
thermal fuses.
Only store CTVS in their original packaging. Do not open the package before storage.
Storage conditions in original packaging: temperature
annual average, maximum 95%, dew precipitation is inadmissible.
Do not store CTVS devices where they are exposed to heat or direct sunlight. Otherwise the
packaging material may be deformed or CTVS may stick together, causing problems during
mounting.
Avoid contamination of the CTVS surface during storage, handling and processing.
Avoid storing CTVS devices in harmful environments where they are exposed to corrosive
gases for example (SO
Use CTVS as soon as possible after opening factory seals such as polyvinyl-sealed packages.
Solder CTVS components after shipment from EPCOS within the time specified:
Do not drop CTVS components and allow them to be chipped.
Do not touch CTVS with your bare hands - gloves are recommended.
Avoid contamination of the CTVS surface during handling.
When CTVS devices are encapsulated with sealing material or overmolded with plastic
material, electrical characteristics might be degraded and the life time reduced.
Make sure an electrode is not scratched before, during or after the mounting process.
Make sure contacts and housings used for assembly with CTVS components are clean before
mounting.
The surface temperature of an operating CTVS can be higher. Ensure that adjacent
components are placed at a sufficient distance from a CTVS to allow proper cooling.
Avoid contamination of the CTVS surface during processing.
Multilayer varistors (MLVs) with AgPd termination are not approved for lead-free soldering.
Complete removal of flux is recommended to avoid surface contamination that can result in an
instable and/or high leakage current.
Use resin-type or non-activated flux.
Bear in mind that insufficient preheating may cause ceramic cracks.
Rapid cooling by dipping in solvent is not recommended, otherwise a component may crack.
CTVS with Ni barrier termination, 12 months
CTVS with AgPd and AgPt termination, 6 months
SHCV and CU series, 24 months
x
, Cl).
Page 79 of 81
25 to +45 C, relative humidity 75%