ZU-1890MU1 Panasonic - ATG, ZU-1890MU1 Datasheet - Page 8

• Manufacturer Part Number: ZU-1890MU1
• Description: CARD READER FULL INSERT USB
• Manufacturer: Panasonic - ATG

Specifications of ZU-1890MU1

• Card Reader Type: Magnetic, Push/Pull
• Interface: USB
• Card Read/write Type And Tracks: Magnetic - Read Tracks 1,2
• Card Reading Direction: Ejection
• Card Standard: ISO 1, ISO 2
• Card Speed: 10 ~ 120 cm/s
• Supply Voltage: 5V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: PCR220

8. Unit life and reliability
Magnetic head Life:
9. Period of guarantee
If defects should occur within one year after acceptance inspection of the machine due to improper material or
workmanship, the defective parts shall be replaced or repaired, free of charge.
10. Maintenance
Because of difficulty in changing components on the P.C Board, replacement of whole unit is recommended for
service and maintenance.
11. Precautions
Please be noted that we do not guarantee proper performance of the card reader if it is used other than the
indicated specification range.
11.1. Handling


11.2. Cautions
Card


Cleaning

© 2005 Panasonic Communications Co., Ltd.
Devices and Components Company Information Equipment Category
Do not drop or give excessive shocks to this unit.
Do not disassemble this unit.
Be sure to use a card, which conforms for the card specification. (please refer to “ 5. Card specification” on
page 2)
Store the card carefully so as not to soil, injure or deform it. In particular, deposit of solid matter on the
magnetic stripe surface may result in a trouble.
Clean the magnetic head by periodically passing a cleaning card.
For example, in a clean office room, pass the cleaning card about once a week.
If the magnetic head is heavily stained, clean the head by soaking the cleaning card in alcohol properly and
pass the card. For example, in the case that the card readers are used in the environment full of dust, please
make a cleaning of the card reader with a cleaning card with alcohol everyday.
Note:
The life is reliability number based on the result tested in a “ clean office” environment.
Above life cycles are the numbers which are tested in a “ clean office environment“ .
These numbers may be shortened dependent on the actual environment.
Especially in a dusty environment*, even in the indoor application, dust or sand may shorten the
life against the mechanical parts and most of the card transport mechanisms.
In these case, warranty of the card reader may be void unless the proper protection and
countermeasures are performed by the terminal side.
(e.g. If used in dusty conditions, the life of the magnetic head will decrease from 1/3 to 1/5 of the
above values.)
*Dusty environment: Refer to ex.) IEC 68, EN30721-3-3 class 3S2 or worse.
300,000 times pass
Specification for ZU-1890MU1
Specification No. MIS-DG60C130A
Page. 5