SDSCB-056G-000000 SanDisk, SDSCB-056G-000000 Datasheet - Page 22

• Manufacturer Part Number: SDSCB-056G-000000
• Description: SSD 2.5" SATA 56GB
• Manufacturer: SanDisk
• Series: SSD SATAr

Specifications of SDSCB-056G-000000

• Memory Size: 56GB
• Memory Type: FLASH - Nand
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: FFD-25-SATA-56-B-P; FFD-25-SATA-56-B-P

4.4.1.10 Sanitizing Based on USA Air Force AFSSI 5020
The USA Air Force System Security Instruction (AFSSI) 5020, dated 20 August, 1996, specifies
the procedure for sanitizing confidential media. Chapter 5, Semiconductor Devices, describes the
security procedure for all types of semiconductor media. In Paragraph 5.3, the procedure for
sanitizing flash memory is described as follows:


The SSD complies with the above requirement, as described in Table 10.
4.4.1.11 Sanitizing (Purging) Based on USA Army Regulation 380-19
The USA Army Regulation 380-19, Information Systems Security (ISS), effective 27 March,
1998, provides the security requirements for systems processing Special Access Program (SAP)
information and describes the ISS policy as it applies to security in hardware, software
procedures, telecommunication, personal use, physical environment, networks and firmware.
Section VII, Automated Information System Media, Section 2-20, describes cleaning, purging,
declassifying and destroying media. Appendix F-2 describes the following for sanitizing flash
EPROM (FEPROM):


The SSD complies with the above requirement, as described in Table 10.
4.4.1.12 Sanitizing (Purging) Based on USA Navy NAVSO P-5239-26
The Navy Staff Office Publication (NAVSO) 5239, “Information Systems Security (INFOSEC)
Program Guidelines” is issued by the Naval Information Systems Management Center and
provides policy, guidelines, and procedures for clearing and purging computer system memory
and other storage media for release outside of and for reuse within controlled environments. It
pertains to both classified and sensitive unclassified information. Implements DOD 5200.28-M
and CSC-STD-005-85. Chapter 3 describes the cleaning and purging of data storage media, and
section 3.5 describes the purging of EEPROM and EAROM. To purge EEPROM:

The SSD complies with the above requirement, as described in Table 10.
4.4.1.13 Declassification Based on IRIG-106 (NTISSP-9)
The Telemetry Group (TG) of the Range Commanders Council (RCC) has prepared documents
to foster the compatibility of telemetry transmitting, receiving, and signal processing equipment
at the member ranges under the cognizance of the RCC.
IRIG (Inter-Range Instrumentation Group) 106 are set of Telemetry standards which provide the
necessary criteria on which to base equipment design and modification.
14
“Pulsing the erase control gate and verifying the erasure”.
“Overwrite all bit locations with arbitrary unclassified data”.
“Overwrite all location with a random character, a specific character, then its complement”
“Check with the DAA (Designated Approval Authority)/SCO (Service Certifying
Organization) to see if additional procedures are required”.
”Overwrite all location with any pattern,” then erase.
Then
Then
Product Specification and User Manual
SSD (Formerly FFD) Serial ATA 2.5"
42-PS-0605-00 Rev. 1.3