CT-1205CL CUI Inc, CT-1205CL Datasheet - Page 3

• Manufacturer Part Number: CT-1205CL
• Description: BUZZER AUDIO MAGNETIC 5VDC SMD
• Manufacturer: CUI Inc
• Series: CTr
• Type: Magnetic Indicator, Internal Driver

Specifications of CT-1205CL

• Frequency: 2.4kHz
• Voltage - Rated: 5VDC
• Current Rating: 30mA
• Size / Dimension: Square - 12.8mm L x 12.8mm W x 7.1mm H
• Mounting Type: Surface Mount
• Sound Pressure Level: 88dB
• Operating Mode: Continuous
• Voltage Range: 4 ~ 7VDC
• Termination: Solder Pads
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Frequency: -
• Other names: 102-1267-2

PART NUMBER: CT-1205CL
MECHANICAL CHARACTERISTICS
item
solderability
soldering heat resistance
terminal mechanical strength
vibration
drop test
ENVIRONMENT TEST
item
high temp. test
low temp. test
thermal shock
temp. cycle test
20050 SW 112
th
Ave. Tualatin, Oregon 97062
test condition
Lead terminals are immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
The product should follow the reflow
temperature curve to test its reflow thermo
stability.
For 10 seconds, the force of 9.8N (1.0kg) is
applied to each terminal in axial direction.
The buzzer will be measured after applying
a vibration amplitude of 1.5 mm with 10 to
55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part will be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axes (X, Y, Z) for a total of 9 drops.
test condition
After being placed in a chamber at +85°C for
96 hours.
After being placed in a chamber at -40°C for
96 hours.
The part shall be subjected to 10 cycles. One
cycle will consist of:
The part shall be subjected to 10 cycles. One
cycle will last 24 hours and will consist of:
phone
phone [phone] fax
DESCRIPTION: magnetic buzzer
fax [phone]
evaluation standard
i initial measurements.
evaluation standard
should be within ±10% of the
initial measurements.
95% of the surface of the lead
pads will be wet with solder.
No interference in operation.
No damage or cutting off.
After the test, the part will meet
specifications without any
damage in appearance and the
SPL should be within ±10% of the
After the test, the part will meet
specifications without any
damage in appearance except
SPL. After 4 hours at 25°C, SPL
rev.
page
date
03/2010
3 of 5