RR1220P-101-B-T5 Susumu, RR1220P-101-B-T5 Datasheet - Page 8
![RES 100 OHM 1/10W .1% 0805 SMD](/photos/12/86/128631/rr_0402_series_sml.jpg)
RR1220P-101-B-T5
Manufacturer Part Number
RR1220P-101-B-T5
Description
RES 100 OHM 1/10W .1% 0805 SMD
Manufacturer
Susumu
Series
RRr
Datasheet
1.RR1220P-3921-D-M.pdf
(14 pages)
Specifications of RR1220P-101-B-T5
Resistance (ohms)
100
Power (watts)
0.1W, 1/10W
Composition
Thin Film
Temperature Coefficient
±25ppm/°C
Tolerance
±0.1%
Size / Dimension
0.079" L x 0.049" W (2.00mm x 1.25mm)
Height
0.016" (0.40mm)
Lead Style
Surface Mount (SMD - SMT)
Package / Case
0805 (2012 Metric)
Resistance In Ohms
100
Case
0805 (2012 metric)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
Other names
RR1220P-101-B
RR1220P101B
RR12P100BTR
RR1220P101B
RR12P100BTR
TITLE:
6.3 Endurance
6.3.1 Rapid change of temperature
6.3.2 Endurance (Damp heat with load)
6.3.3 Endurance (rated load)
Method;
Specification;
Method;
Specification;
Method;
Specification;
The resistor shall be subjected to 5 continuous cycles, each as shown in the figure below.
For other procedures, refer to IEC 60115-1, Sub-clause 4.19.
Change in resistance
Without mechanical damage such as breaks and distinct damage in appearance.
Marking shall be legible.
The specimen shall be placed in the test chamber at a temperature 40±2deg C and a relative humidity
90 to 95 %, and then subjected to a voltage cycle consisting of rated d.c. voltage application of 1 hr 30
min and rest of 30 min repeatedly for 1000 +48/0 hrs.
However the applied voltage shall not exceed the limited element voltage.
For other procedures, refer to IEC 60115-1, Sub-clause 4.24.
Change in resistance
Without mechanical damage such as breaks and distinct damage in appearance.
Marking shall be legible.
The specimen shall be placed in the test chamber at 70±2deg C, and then subjected to a voltage cycle
consisting of rated d.c. voltage application of 1 hr 30 min and rest of 30 min repeatedly for 1000 +48/0
hrs.
However the applied voltage shall not exceed the limited element voltage.
For other procedures, refer to IEC 60115-1, Sub-clause 4.25.
Change in resistance
Without mechanical damage such as breaks and distinct damage in appearance.
Marking shall be legible.
Chip resistor RR1220 series
1 Minimum operating temperature±3deg C
2 Standard atmospheric conditions
3 Maximum operating temperature±2deg C
4 Standard atmospheric conditions
Specification for
:
:
:
±(0.5%+0.05Ω)
±(0.5%+0.05Ω)
±(0.5%+0.05Ω)
SUSUMU
CO.,LTD
SPEC.NO:
2∼3 min
2∼3 min
30 min
30 min
RR00-1097
Rev. No.
0
8/14