PJRAN1X1U02X Switchcraft Inc., PJRAN1X1U02X Datasheet - Page 69

• Manufacturer Part Number: PJRAN1X1U02X
• Description: CONN JACK 1POS R/A PHONO WHITE
• Manufacturer: Switchcraft Inc.
• Series: PJRr

Specifications of PJRAN1X1U02X

• Gender: Female
• Rohs Information: Switchcraft RoHS Info.
• Connector Type: Phono (RCA) Jack
• Signal Lines: Mono
• Plug/mating Plug Diameter: 3.20mm ID, 9.00mm OD (RCA)
• Number Of Positions/contacts: 2 Conductors, 3 Contacts
• Internal Switch(s): Single Switch
• Mounting Type: Through Hole, Right Angle
• Termination: Solder
• Shielding: Unshielded
• Color: White
• Number Of Ports: 1Port
• Body Orientation: Right Angle
• Number Of Terminals: 2
• Contact Material: Copper Alloy
• Number Of Contacts: 2POS
• Mounting Style: Through Hole
• Termination Method: Solder
• Operating Temp Range: -25C to 85C
• Contact Plating: Silver
• Voltage Rating: 34 Volts
• Current Rating: 2 Amps
• Orientation: Right Angle
• Shell Plating: Steel
• Termination Style: Solder
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

64
w w w . s w i t c h c r a f t . c o m
CONNECTORS & RECEPTACLES
SLIM-LINE CONNECTORS
SLIM-LINE CONNECTORS
SL18 RECEPTACLES
Front of Panel Mount
SL MALE RECEPTACLES
SL FEMALE RECEPTACLES
SLIM-LINE CONNECTORS (continued)
Front of panel mount; 2 through 5 pins (male) or 2 through
5 contacts (female). Also 2-, 3- and 4-contact insert with
3 shunted (N.C.) contacts. Mounting locknut (Part Number
SL01), lockwasher (Part Number SL02), and flat washer
(Part Number SL03) supplied.
Part Number
Part Number
SL182M
SL183M
SL184M
SL185M
SL182F
SL183F
SL184F
SL185F
(17.7)
.696
Contacts
PANEL HOLE
Pins
2
3
4
5
2
3
4
5
Arrangements
SL183FS (typical)
Arrangements
DIMENSIONS ARE FOR REFERENCE ONLY
Contact
Pin
1
2
3
4
A
B
C
D
INSTALLING CABLE CLAMP ON INSERT
To install cable clamp on any insert:
1. Position insert approximately as shown in the diagram.
2. Hold clamp at approximately 30° angle (as shown). Place
3. Press center finger forward into slot and reduce angle of
Cable Clamp SL04
tip of clamp center finger into slot under molded ring “A”.
Note position of notch on insert in relation to slot.
clamp until clamp shoulders seat just ahead of molded
barrier on rear of insert “B”.
MOLDED
RING
“A”
INSERT
NOTCH
ON
(mm)
Note: Contact your Switchcraft Representative for price and delivery
Inch
PHONE: 773 792 - 2700
® Registered trademark of Switchcraft, Inc.
INSERT
“B”
CABLE
CLAMP