73S1209F-68IMR/F Maxim Integrated Products, 73S1209F-68IMR/F Datasheet - Page 86
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
73S1209F-68IMR/F
Manufacturer Part Number
73S1209F-68IMR/F
Description
IC SMART CARD READER 68-QFN
Manufacturer
Maxim Integrated Products
Datasheet
1.73S1209F-44IMF.pdf
(93 pages)
Specifications of 73S1209F-68IMR/F
Core Processor
80515
Core Size
8-Bit
Speed
24MHz
Connectivity
I²C, SmartCard, UART/USART
Peripherals
LED, POR, WDT
Number Of I /o
9
Program Memory Size
32KB (32K x 8)
Program Memory Type
FLASH
Ram Size
2K x 8
Voltage - Supply (vcc/vdd)
2.7 V ~ 5.5 V
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
*
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Eeprom Size
-
Data Converters
-
Lead Free Status / Rohs Status
Details
73S12xxF Software User Guide
UG_12xxF_016
4.5.1 EMV LEVEL I Certification Tests
The EMV compliant test suite follows the Payment System Environment specification. There are several
test labs, listed on the
www.emvco.com
website, qualified to perform these tests.
Currently, there are two available Protocol test suites that can be used to qualify for EMV Level I
compliance. Passing either of these suites will qualify as EMV Level I compliance. The Pseudo-CCID
code links to the two TSC libraries LAPI and HAPI which comply with both tests. However, since each
lab has its own test scripts and the test scripts differ according to the lab’s setup, the application layer
must be written and adapted specifically for each test lab’s requirements. The following subsections
describe the loopback tests that are to be written either on the host side or added to the TSC Pseudo-
CCID firmware.
4.5.1.1 EMV Test Mode
An EMV test (or session) is defined as a Command/Response pair that runs from the Activation of the
card to the Deactivation of the card. A Block Transfer may or may not occur during the session
depending on the card’s ATR response.
The host may set up the EMV PSE test environment via the USB CCID Card Control command (Escape
command). The first parameter byte (B1) of the Escape command must specifically indicate whether a
test mode is invoked and if so, it should be invoked using the MCI, VISA I or VISA II test environment.
Review the Escape command section for details about this test mode.
Following a successful Escape command, the host should start the test by sending the PowerOn
command (ScardConnect). Depending on the status of the ATR (good or bad), the host should send an
empty Block Transfer command without the APDU command (command length = 0). For example: 6F
00 00 00 00… CRC.
The test loopback will be handled by the firmware and upon completion of each test, the firmware will
respond to the host with the status, indicating whether the test session completed with a successful
return code or not. An unsuccessful return code may or may not indicate that the test failed. The test
result (test passed or test failed) is determined only by the card side.
Figure 11
depicts the minimal coding required on the host side to invoke the EMV PSE test environment.
86
Rev. 1.50