EVAL-ADM1073MEB Analog Devices Inc, EVAL-ADM1073MEB Datasheet - Page 3

no-image

EVAL-ADM1073MEB

Manufacturer Part Number
EVAL-ADM1073MEB
Description
BOARD EVAL MICRO FOR ADM1073
Manufacturer
Analog Devices Inc
Datasheet

Specifications of EVAL-ADM1073MEB

Main Purpose
Power Management, Hot Swap Controller
Utilized Ic / Part
ADM1073
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Secondary Attributes
-
Embedded
-
Primary Attributes
-
EVALUATION BOARD HARDWARE
IMPORTANT
Take the following precautions, when using the
EVAL-ADM1073EB evaluation kit under high voltage
conditions:
CONNECTOR, SWITCH, JUMPER, AND LED FUNCTIONS
Table 1. Connector Functions
Pin
J1
J2
J3
J4
J5
J6
J7
J8
J9
J10
J11
J12
J13
J14
Do not work alone.
Always keep one hand in your pocket or behind your back
when around a high voltage system.
Wear footwear with a rubber bottom.
Wear eye protection (safety goggles).
Do not wear any jewelry or other articles that could
accidentally contact circuitry and conduct current.
Work on an antistatic mat.
Name
−48VRTN
−48VIN
−48VIN
−48VIN
V
−48VOUT
UV
−48VRTN
OV
IN
Function
Black Banana Connector. −48 V return input voltage line.
Blue Banana Connector. −48 V input voltage line.
Blue Banana Connector. −48 V input voltage line (diode OR’ed with J4 input).
Blue Banana Connector. −48 V input voltage line (diode OR’ed with J3 input).
SMB Connector. V
Blue Banana Connector. −48 V output voltage line.
SMB Connector. UV voltage can be monitored or applied via J5.
Edge Connector. Allows connection of a backplane board for powering the board and simulating hot swap events.
Edge Connector. Allows connection of a load board for simulating hot swap events.
Black Banana Connector. −48 V return output voltage line.
SMB Connector. OV voltage can be monitored or applied via J11.
SPLYGD, PWRGD, and LATCHED outputs can monitored via J12.
SHDN and RESTART inputs can be applied or monitored via J13.
Allows an external voltage to be applied to overdrive the SS pin. This alters the internal current limit reference voltage,
which, in effect, alters the current limit level.
J12-1: Feed SPLYGD to J12-1 by closing S7-3 switch.
J12-2: Feed PWRGD to J12-2 by closing S7-6 switch.
J12-3: Feed LATCHED to J12-3 by closing S7-9 switch.
J13-1: Feed SHDN to J13-1 by closing S5-6 switch.
J13-2: Feed RESTART to J13-2 by closing S5-2 switch.
J14-1: Applies SS voltage to this terminal.
J14-2: ADM1073 V
IN
voltage can be monitored via J5.
EE
voltage.
Rev. 0 | Page 3 of 20
Set up your work area away from possible grounds that you
might accidentally contact.
Connect/disconnect any test leads with the power off and
the equipment unplugged. Use clip leads or solder
temporary wires to reach difficult-to-access locations.
Perform as many tests as possible with the power off and
the equipment unplugged.
After tests have been performed with the power applied,
turn off the power and disconnect the power supply from
the board.
Fully discharge large load capacitors with an appropriate
resistor.
EVAL-ADM1073EB

Related parts for EVAL-ADM1073MEB