DEMOBOARD-U3600BM Atmel, DEMOBOARD-U3600BM Datasheet - Page 35

• Manufacturer Part Number: DEMOBOARD-U3600BM
• Description: BOARD DEMO FOR U3600BM
• Manufacturer: Atmel
• Type: Cordless Phone ICr

Specifications of DEMOBOARD-U3600BM

• Contents: Board, Software and Documentation
• For Use With/related Products: U3600BM
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

10. Installation Procedure
11. Software Installation
12. System Requirements
13. Configuration of the U3600BM Demonstration Software
4804A–CT0–03/06
For demonstration of these integrated circuits, use the U3600BM demo board.
As the U3600BM is controllable via a serial bus (to load all the internal registers), Atmel provides
demonstration and development software.
The software is written in Visual Basic and replaces the previously used microcontroller.
Please note that the Visual Basic program controls all of the U3600BM's registers, but it does
not work as a complete telephone processor to handle all protocols needed to communicate
between base station and handset or vice versa.
To connect the demo board to the personal computer, see
After following the instructions to load the software, the following options may be selected
depending on your configuration and needs.
1. Copy U3600in.exe to your PC and remove the CD-ROM. (Saving the executable in a
2. Execute U3600in.exe to unpack all necessary files.
3. Execute setup.exe to install the demonstration software. You will be asked for a direc-
4. Start the software by double-clicking on U3600.exe.
• IBM
• Windows
• Printer port 1, 2 or 3 (port is selectable via software)
1. Interface (LPT1/LPT2/LPT3)
2. Auto-Send ON/OFF
software does not run under Windows NT
The PC's parallel port is used for the communication between PC and demo board. Use the
radio buttons LPT1/LPT2/LPT3 to select the parallel port in use.
After modification of a register bit, the modified bit can be transmitted automatically or
manually.
To transmit a bit to the U3600BM register via the serial bus immediately after modification,
select the ON radio button.
If the OFF radio button is selected and one or more bits are modified, the bits are not trans-
ferred until the Send button, located below the register bits, is pressed.
new directory will make later clean-up easier, as the directory of temporary files can be
deleted following install.)
tory in which to put the executable.
®
-compatible PC x386 or higher
®
3.xx or higher (Visual Basic software runs only under Windows
®
.)
Figure 21-2 on page 41
®
U3600BM
. The demo
35