DC-ANT-E-24DT-25 Digi International, DC-ANT-E-24DT-25 Datasheet - Page 21
![no-image](/images/manufacturer_photos/0/1/193/digi_international_sml.jpg)
DC-ANT-E-24DT-25
Manufacturer Part Number
DC-ANT-E-24DT-25
Description
CORD EXT 30CM W/RP-SMA CONN (25)
Manufacturer
Digi International
Datasheet
1.DC-ANT-E-24DP.pdf
(42 pages)
Specifications of DC-ANT-E-24DT-25
Accessory Type
Extension Cord
For Use With/related Products
Dipole Antennae
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
General information
GPIO Pin Use
LEDs
PORTA7 - PORTA0
PORTC4 - PORTC0
Register Bit
PORTC7
PORTC6
PORTC5
The device server has two types of LEDs:
The development kit supplies software to control the LEDs. This behavior can often be
modified by manipulating the LED table in the BSP code. See gpio.c for details.
As with any GPIO output, the GPIO register must be properly configured in order to assert
values on the pin. The appropriate bits should be configured as:
LEDs connected directly to GPIO pins on the processor and controlled directly
in software
LEDs connected to other hardware components (normally the Ethernet
hardware) and not directly programmable by the operating system
CMODE = 0
CDIR = 1
Category
Allocated
Available
Reserved
Reserved
Reserved
Connected to the
Connected to the
Interface
GPIO Pin Use
reset button.
External
red LED
NA
NA
NA
Used as a power indicator (always on). It could
be reassigned as a general purpose LED. It
must remain a GPIO output for the LED to
operate correctly. The LED is lit when the
signal is a logic "high."
It should be configured as a GPIO input.
Description
NA
NA
NA
2 1