UPC2708T CEL, UPC2708T Datasheet - Page 13

• Manufacturer Part Number: UPC2708T
• Description: MMIC AMP 3GHZ SOT-26
• Manufacturer: CEL

Specifications of UPC2708T

• Current - Supply: 20mA ~ 33mA
• Frequency: 2.7GHz ~ 3GHz
• Gain: 13dB ~ 18.5dB
• Noise Figure: 6.5dB ~ 8dB
• Package / Case: SOT-26
• Rf Type: Cellular, DBS, PCS
• Voltage - Supply: 4.5 V ~ 5.5 V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• P1db: -
• Test Frequency: -

NOTES ON CORRECT USE
(1) Observe precautions for handling because of electro-static sensitive devices.
(2) Form a ground pattern as wide as possible to minimize ground impedance (to prevent undesired oscillation).
(3) The bypass capacitor should be attached to V
(4) The inductor must be attached between V
(5) The DC cut capacitor must be attached to input pin.
RECOMMENDED SOLDERING CONDITIONS
conditions other than those recommended below, contact your NEC sales representative.
SEMICONDUCTOR DEVICE MOUNTING TECHNOLOGY MANUAL (C10535E).
PC2708T
Infrared Reflow
VPS
Wave Soldering
Partial Heating
Soldering Method
This product should be soldered under the following recommended conditions.
Note After opening the dry pack, keep it in a place below 25°C and 65% RH for the allowable storage period.
Caution Do not use different soldering methods together (except for partial heating).
For details of recommended soldering conditions for surface mounting, refer to information document
All the ground pins must be connected together with wide ground pattern to decrease impedance difference.
accordance with desired frequency.
Package peak temperature: 235°C or below
Time: 30 seconds or less (at 210°C)
Count: 3, Exposure limit
Package peak temperature: 215°C or below
Time: 40 seconds or less (at 200°C)
Count: 3, Exposure limit
Soldering bath temperature: 260°C or below
Time: 10 seconds or less
Count: 1, Exposure limit
Pin temperature: 300°C
Time: 3 seconds or less (per side of device)
Exposure limit
Note
: None
Note
Note
Note
Soldering Conditions
: None
: None
: None
CC
CC
and output pins. The inductance value should be determined in
line.
For soldering methods and
Recommended Condition
Symbol
WS60-00-1
VP15-00-3
IR35-00-3
PC2708T
–
13