X24-019-DK Digi International/Maxstream, X24-019-DK Datasheet - Page 4

• Manufacturer Part Number: X24-019-DK
• Description: KIT DEV 2.4GHZ 19.2K W/RPSMA
• Manufacturer: Digi International/Maxstream
• Series: XStream™r
• Type: Transceiverr

Specifications of X24-019-DK

• Frequency: 2.4GHz
• For Use With/related Products: XStream Module 2.4 GHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: X24-019NSC-DK; X24-019NSC-DK

Tips and Suggestions
Contact MaxStream
Interface Board DIP Switch Configurations
Figure 5. DIP Switch Se�ings (Se�ings applied only during power-up sequence)
Restore Module to its Default AT Settable Parameter Values
Create a Wireless Link between Serial Devices
The MaxStream Interface Board DIP Switch allows users an exterior method for
configuring "Serial Interface" and "Termination" parameter settings.
If module is not
responding or
cannot enter
Command Mode,
try restoring the
modem to its
original settings.
A pair of module assemblies can be used in lieu of a serial cable to create a
wireless link between devices. The topology below illustrates a basic wireless
strategy that can be used when connecting to target devices such as automatic
meter readers, fleet management devices, remote weather stations and a host of
other applications. When creating a wireless link, consider the following:
(To verify serial cabling is functioning properly, insert a female-to-female NULL
modem adapter in place of Radio1 and Radio2, then test communications
without the module assemblies in the link.)
• Use the male-to-male NULL modem adapter to connect Radio2 to a
Phone: [phone], Live Chat: www.maxstream.net, E-mail: [e-mail]
target serial device. [Figure 6] Pin signals crossover inside the adapter.
Figure 6. Wireless link between devices
Serial Interface
Switches 1 & 2
1 2
= RS-232
= 2-wire RS-485
=
= (Restore Defaults)
4-wire
RS-485/422
To Restore Defaults (using X-CTU Software):
1. Connect module assembly to host PC [steps 1-2 of the
2. Match PC Settings with those of the module [steps 1-3 of
the ‘Range Test’ instructions on page 3].
3. Launch X-CTU Software & select “Modem Configuration” tab.
4. Select the “Restore” button.
(Office hours are 8am – 5pm U.S. Mountain standard time)
‘Hardware Setup’ instructions on page 2 of this guide].
(w/ wire antenna)
O
N
3 4
Radio1
1 2 3 4 5 6
Termination
RS-485/422
Switches 3 & 4
=
=
=
2-wire RS-485
Termination
4-wire RS-485/422
Termination
None
Target Serial Device
= Invalid
male-to-male NULL modem adapter
Parity
Switches 5 & 6
5 6
=
= Even
= Odd
=
(w/ RPSMA antenna)
None
9-bit
(v4.30 only)
Radio2
= ON (up)
= OFF (down)