AD6655-150EBZ Analog Devices Inc, AD6655-150EBZ Datasheet - Page 58

• Manufacturer Part Number: AD6655-150EBZ
• Description: BOARD EVAL FOR 150MSPS AD6655
• Manufacturer: Analog Devices Inc
• Type: Receiverr

Specifications of AD6655-150EBZ

• Frequency: 0Hz ~ 450MHz
• Silicon Manufacturer: Analog Devices
• Application Sub Type: IF Diversity Receiver
• Kit Application Type: Communication & Networking
• Silicon Core Number: AD6655
• Kit Contents: Evaluation Board With AD6655 And Software
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: AD6655
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

AD6655
Bit 0—NCO32 Enable
When Bit 0 is set, this bit enables the 32-bit NCO operating at
the frequency programmed into the NCO frequency register.
When Bit 0 is cleared, the NCO is bypassed and shuts down for
power savings.
NCO Frequency (Register 0x11E to Register 0x121)
Register 0x11E, Bits[7:0]—NCO Frequency Value[7:0]
Register 0x11F, Bits[7:0]—NCO Frequency Value[15:8]
Register 0x120, Bits[7:0]—NCO Frequency Value[23:16]
Register 0x121, Bits[7:0]—NCO Frequency Value[31:24]
This 32-bit value is used to program the NCO tuning frequency.
The frequency value to be programmed is given by the
following equation:
where:
NCO_FREQ is a 32-bit twos complement number representing
the NCO frequency register.
f is the desired carrier frequency in hertz (Hz).
f
CLK
is the AD6655 ADC clock rate in hertz (Hz).
NCO_FREQ
=
2
32
×
Mod
(
f
CLK
f
,
f
CLK
)
Rev. A | Page 58 of 88
NCO Phase Offset (Register 0x122 and Register 0x123)
Register 0x122, Bits[7:0]—NCO Phase Value[7:0]
Register 0x123, Bits[7:0]—NCO Phase Value[15:8]
The 16-bit value programmed into the NCO phase value register
is loaded into the NCO block each time the NCO is started or
when an NCO SYNC signal is received. This process allows the
NCO to be started with a known nonzero phase.
Use the following equation to calculate the NCO phase offset
value:
where:
NCO_PHASE is a decimal number equal to the 16-bit binary
number to be programmed at Register 0x122 and Register 0x123.
PHASE is the desired NCO phase in degrees.
NCO_PHASE = 2
16
× PHASE/360