DC-WEM-02T-JT-DB Digi International, DC-WEM-02T-JT-DB Datasheet - Page 24

• Manufacturer Part Number: DC-WEM-02T-JT-DB
• Description: BOARD DEV WI-EM MODULE JTAG
• Manufacturer: Digi International
• Series: Digi Connect Wi-EM®r
• Type: 802.11br

Specifications of DC-WEM-02T-JT-DB

• Frequency: 2.4GHz
• Wireless Frequency: 2.4 GHz
• Interface Type: SMA
• Modulation: CCK, DBPSK, DQPSK
• Security: 64/128 WEP, WPA, 802.11i, TKIP
• For Use With/related Products: Digi Connect Wi-EM S Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1011

Ethernet Port (P12)
GPIO Port (P3)
2 4
P o r t s
       
The Ethernet port of the Digi Connect EM embedded module (labeled P12) is an 8-pin
RJ-45 jack meeting the requirements of ISO 8877 for 10/100Base-T. When two
descriptions are shown for a pin, the second is for use with 802.3af powered Ethernet.
For additional information about the 802.3af standard, refer to the corresponding IEEE
specification.
Note:
The GPIO port is a 10-pin male right-angle connector (labeled P3). See the following
figure and table for pin orientation and pin assignments.
GPIO Port Pin Orientation
D i g i C o n n e c t E M & W i - E M H a r d w a r e R e f e r e n c e
The development board provides a reference design of a POE (Power Over
Ethernet) power supply. A schematic for this reference design is installed by
the setup program on the CD.
Pin
1
2
3
4
5
6
7
8
TXD+ (Transmit Data)
TXD- (Transmit Data)
RXD+ (Receive Data)
Not used / power (+)
Not used / power (+)
RXD- (Receive Data)
Not used / power (-)
Not used / power (-)
Signal Name
Ethernet Pin Assignments
Pin 1
Pin 10
RJ-45 (P12)
Pin
1
Figure