DC-WEM-02T-GN Digi International, DC-WEM-02T-GN Datasheet - Page 27

• Manufacturer Part Number: DC-WEM-02T-GN
• Description: KIT DEV WI-EM MODULE C MODELS
• Manufacturer: Digi International
• Series: Digi Connect Wi-EM®r
• Type: 802.11br

Specifications of DC-WEM-02T-GN

• Frequency: 2.4GHz
• Wireless Frequency: 2.4 GHz
• Interface Type: SMA
• Modulation: CCK, DBPSK, DQPSK
• Security: 64/128 WEP, WPA, 802.11i, TKIP
• For Use With/related Products: Digi Connect Wi-EM C Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1009

SPI Jumper Block
Logic Signal Analyzer Header (P6)
Signal
SPI-EN
Pin
1
The SPI jumper block determines whether the SPI connector is connected or not. If SPI is
off (the default), serial and GPIO signals are routed to switch banks 1 through 4. (See
"Serial/GPIO Switch Bank 3 (SW3) and Switch Bank 4 (SW4)" on page 30 and "GPIO
Switch Bank 1 (SW1) and 2 (SW2)" on page 31.) If SPI is on, SPI signals are routed to the
SPI connector (P11).
The following figures demonstrate how to set the SPI jumper block
SPI Jumper Settings
This 20-pin male vertical header (labeled P6) connects a digital signal analyzer (for
example, a logic analyzer) to the development board. It is used with the development kit
only. See the following figure and table for pin orientation and pin assignments.
GND
Pin
2
SPI-CLK
Pin
3
SPI Pin Assignments
SPI OFF
GND
Pin
4
o
SPI-TX
Pin
5
GND
Pin
6
SPI-RX
Pin
7
A b o u t t h e D e v e l o p m e n t B o a r d
GND
Pin
8
SPI ON
o
connected
Pin
Not
9
connected
      
Pin
10
Not
2 7