AMHIRK-315AR3 RF Solutions, AMHIRK-315AR3 Datasheet - Page 2

• Manufacturer Part Number: AMHIRK-315AR3
• Description: RECEIVER RF MINI 315MHZ
• Manufacturer: RF Solutions

Specifications of AMHIRK-315AR3

• Frequency: 315MHz
• Modulation Or Protocol: AM
• Applications: AM Remote Control
• Data Interface: PCB, Through Hole
• Antenna Connector: Through Hole
• Features: EMC Compliant and FCC Certified
• Voltage - Supply: 5V
• Operating Temperature: -30°C ~ 85°C
• Package / Case: Module
• Sensitivity: -
• Memory Size: -
• Data Rate - Maximum: -
• Current - Receiving: -

DS010-7
HiRK Versions
This range of modules provides a high sensitivity and selective Superhetrodyne receiver, combined with flash
programmable controller, supplied pre-programmed to operate with a suitable Keeloq Transmitter encoder.
The range from such a system can be up to 150 metres Lin of Sight (LOS).
Custom versions of this product are available, please contact our sales department for further details
Pin Descriptions Superhetrodyne Versions (HiRK series)
Compatibility with older versions of this module
** AM-HiRK: To remain compatible with previous versions of the product, this pin may be removed and
AM-HiRH :
Pin No
Nov 08
11
13
14
15
16
17
18
19
20
21
22
23
24
25
1
2
3
7
Vdd-digital
Vcc-digital
ignored.
Please contact sales for part HiRK-433P534
GND-RF
GND-RF
GND-AF
MCLR**
Vcc-RF
O/P-AF
Name
Link2
Link1
RSSI
PSW
O/P2
O/P3
O/P4
O/P1
ANT
LED
RF R
+5V Supply Voltage – RF section
RF Ground
Connect Antenna to this input
RF Ground
AF Ground
Received Signal Strength Indicator (RSSI)
Raw Data output from RF receiver (CMOS/TTL signal)
+5V Supply Voltage – digital section
Digital Ground
Pulls Microcontroller into reset if connected to Ground
May be left unconnected if not required (internally tied high)
Connect to GND to make link, may be left O/C if not required
Connect to GND to make link, may be left O/C if not required
Programming Switch input. Used when learning new transmitters and erasing data.
External LED sink output, can be connected directly to cathode of external LED.
Connect Anode of the LED directly to +5V.
Indicates Data reception, and programming status.
Active High data Output 2 (has a 220Ω series resistor)
Active High data Output 3 (has a 220Ω series resistor)
Active High data Output 4 (has a 220  s eries resistor) or
Battery Low Output: Indicates when the transmitter battery is low voltage (Output is
high when battery low)
Serial Data Output: Outputs the Serial ID of transmitter encoder. Please see RF600
for serial data format and timings
Active High data Output 1 (has a 220Ω series resistor)
ECEIVER
©2006 REG No 277 4001, England.
D
ECODER
H
Description
YBRID
Page 2
.
HIRK-315
HIRK-433
HIR6-433