ZAXM-201-1 CEL, ZAXM-201-1 Datasheet - Page 6

• Manufacturer Part Number: ZAXM-201-1
• Description: MODULE ZIGBEE 802.15.4
• Manufacturer: CEL

Specifications of ZAXM-201-1

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: AMR, ISM, ZigBee™
• Sensitivity: -96dBm
• Voltage - Supply: 2.4 V ~ 3.6 V
• Current - Receiving: 37mA
• Current - Transmitting: 170mA @ 100mW
• Data Interface: PCB, Surface Mount
• Memory Size: 128kB Flash, 5kB SRAM
• Antenna Connector: On-Board, Trace
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz to 2.5 GHz
• Interface Type: SPI, I2C, UART
• Security: 128 bit AES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: XAP2b

ZAXM-200 Series
MODES OF OPERATION
The Apex supports three power modes: Processor ACTIVE, processor IDLE, and DEEP SLEEP.
Processor ACTIVE
In this mode all operations are running normally.
Processor IDLE
In this mode the processor stops code execution of the XAP2b microprocessor until any interrupt occurs or external SIF
wake up command is seen. The radio is operating normally in this mode.
Deep Sleep
To achieve the lowest power consumption, the module can be set in DEEP SLEEP mode. In this mode most of the function-
alities of the modules are turned off with the exception of the critical functions such as GPIO pads and RAM that is powered
by the high voltage supply (DCC_PADS).
The module can be taken out of DEEP SLEEP in 3 ways:
• Configuring the sleep timer to generate an interrupt after some periods of time.
• Issuing external interrupt signal.
• Issuing commands through the SIF interface.
In DEEP SLEEP the current consumption of the module will drop to 5.0μA (5.5μA with optional 32.768kHz oscillator
enabled).
For more detail information on modes of operation refer to Ember EM250 datasheet available at Ember’s
website (www.ember.com)