DC-WEM-02T-NC Digi International, DC-WEM-02T-NC Datasheet - Page 24

• Manufacturer Part Number: DC-WEM-02T-NC
• Description: WI-EM 8MB SDRAM 4MB FLASH SINGLE
• Manufacturer: Digi International
• Series: Digi Connect® Wi-EMr

Specifications of DC-WEM-02T-NC

• Frequency: 2.4GHz
• Data Rate - Maximum: 11Mbps
• Modulation Or Protocol: 802.11 b
• Applications: General Purpose
• Power - Output: 16dBm
• Sensitivity: -82dBm
• Voltage - Supply: 3.14 V ~ 3.45 V
• Data Interface: Connector, DB-9M
• Memory Size: 4MB Flash, 8MB RAM
• Antenna Connector: 2 X RP-SMA
• Operating Temperature: 0°C ~ 55°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Other names: 602-1067

Ethernet Port (P12)
GPIO Port (P3)
2 4
P o r t s
       
The Ethernet port of the Digi Connect EM embedded module (labeled P12) is an 8-pin
RJ-45 jack meeting the requirements of ISO 8877 for 10/100Base-T. When two
descriptions are shown for a pin, the second is for use with 802.3af powered Ethernet.
For additional information about the 802.3af standard, refer to the corresponding IEEE
specification.
Note:
The GPIO port is a 10-pin male right-angle connector (labeled P3). See the following
figure and table for pin orientation and pin assignments.
GPIO Port Pin Orientation
D i g i C o n n e c t E M & W i - E M H a r d w a r e R e f e r e n c e
The development board provides a reference design of a POE (Power Over
Ethernet) power supply. A schematic for this reference design is installed by
the setup program on the CD.
Pin
1
2
3
4
5
6
7
8
TXD+ (Transmit Data)
TXD- (Transmit Data)
RXD+ (Receive Data)
Not used / power (+)
Not used / power (+)
RXD- (Receive Data)
Not used / power (-)
Not used / power (-)
Signal Name
Ethernet Pin Assignments
Pin 1
Pin 10
RJ-45 (P12)
Pin
1
Figure