ZB2430-Q-E-S-A Laird Technologies, ZB2430-Q-E-S-A Datasheet - Page 41
![no-image](/images/manufacturer_photos/0/3/378/laird_technologies_sml.jpg)
ZB2430-Q-E-S-A
Manufacturer Part Number
ZB2430-Q-E-S-A
Description
MOD ANT CHIP ZIGBEE 2-100MW SMT
Manufacturer
Laird Technologies
Series
AeroCommr
Datasheet
1.ZB2430-D-C-S-A-EVB.pdf
(62 pages)
Specifications of ZB2430-Q-E-S-A
Frequency
2.4GHz
Data Rate - Maximum
250kbps
Modulation Or Protocol
802.15.4 Zigbee
Applications
AMR, ISM, Security and Access
Power - Output
10dBm ~ 20dBm
Sensitivity
-99dBm
Voltage - Supply
3 V ~ 3.5 V
Current - Receiving
27mA
Current - Transmitting
25mA
Data Interface
PCB, Surface Mount
Antenna Connector
On-Board, Chip
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
3 6
C O N F I G U R I N G T H E Z B 2 4 3 0
Upon receiving this command, a transceiver will respond with the
desired data from the addresses requested by the OEM Host.
*Note: Maximum Length is 0xFC.
EE PROM Byte W ri t e
Upon receiving this command, a transceiver will write the data bytes
to the specified address but will not respond to the OEM Host until
the EEPROM write cycle is complete.
Note: The maximum length of data that can be written in a single
write process is 0x50. If writing the entire 256-byte EEPROM, it is
convenient to perform 64 byte (0x40) writes.
R es et
The OEM Host issues this command to perform a soft reset of the
transceiver. Any transceiver settings modified by CC commands will
revert to the values stored in the EEPROM.
R es t o r e F a ct o r y D ef a u l ts
The OEM Host issues this command to restore the EEPROM
Configuration to factory default.
*Note. This command does not perform a NV Reset.
S o f t Re s et w i t h N V r e s et
The OEM Host issues this command to perform a soft reset of the
transceiver and to erase the network settings stored in the radio’s
non-volatile memory.
commands will revert to the values stored in the EEPROM.
Any transceiver settings modified by CC
Command: <0xCC> <0xC0> <Start> <Length>
Number of Bytes Returned: 4+
Response: <0xCC> <Start> <Length> <Data>
Parameter Range:
<Start>
<Length>
<Data>
Command: <0xCC> <0xC1> <Start> <Length> <Data>
Number of Bytes Returned: 3
Response: <Start> <Length> <Last byte>
Parameter Range:
<Start>
<Length>
<Data>
<Last byte> = Value of last byte written
Command: <0xCC> <0xFF>
Number of Bytes Returned: None
Response: None
Command: <0xCC> <0xFF> <0xDF>
Number of Bytes Returned: None
Response: None
Command: <0xCC> <0xFF> <0xE3>
Number of Bytes Returned: None
Response: None
= EEPROM address to begin reading at
= Length of data to be read
= Requested data
= EEPROM address to begin writing at
= Length of data to be written (Max = 0x50)
= Data to be written