IRAMS10UP60B-4 International Rectifier, IRAMS10UP60B-4 Datasheet - Page 7

• Manufacturer Part Number: IRAMS10UP60B-4
• Description: IC PWR MOD PLUG-N-DRIVE 600V 10A
• Manufacturer: International Rectifier
• Series: iMOTION™r
• Type: IGBTr

Specifications of IRAMS10UP60B-4

• Configuration: 3 Phase
• Current: 10A
• Voltage: 600V
• Voltage - Isolation: 2000Vrms
• Package / Case: PCB Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Figure 2. I
Note 5: The shaded area indicates that both high-side and low-side switches are off and therefore the half-bridge output
voltage would be determined by the direction of current flow in the load.
www.irf.com
Sequence of events:
1-2) Current begins to rise
2) Current reaches I
2-3) Current is higher than I
over-current. In case of high current (short circuit), the actual delay will be smaller.
3-4) Delay between driver identification of over-current condition and disabling of all outputs
4) Current starts decreasing, eventually reaching 0
5) Current goes below I
6) Driver is automatically reset and normal operation can resume (over-current condition must be removed
by the time the drivers automatically resets itself)
Trip
HIN1,2,3
LIN1,2,3
U,V,W
I
Timing Waveform
BUS
BUS_Trip
I
BUS_trip
BUS_trip
1
level
BUS_Trip
, the driver starts its auto-reset sequence
2
for at least 6µs. This value is the worst-case condition with very low
6µs
3
1µs
4
5
IRAMS10UP60B
t
fltclr
6
50%
7